Onkyo TX-NR1008 instruction manual Error Messages, Enter

4 If you use a powered subwoofer(s), adjust the sub- woofer volume level to 75dB.

Test tones are played through the subwoofer. Use the volume control on the subwoofer.

Note

• If your subwoofer does not have a volume control, disre- gard the level displayed and press ENTER to proceed to the next step.

• If you set the subwoofer’s volume control to its maximum and the displayed level is lower than 75 dB, leave the sub- woofer’s volume control at its maximum and press ENTER to proceed to the next step.

5 Press ENTER.

Audyssey MultEQ® Room Correction and Speaker Setup starts.

Test tones are played through each speaker as Audyssey MultEQ Room Correction and Speaker Setup runs. This process takes a few minutes. Please refrain from talking during measurements and do not stand between speakers and the microphone. Do not disconnect the speaker setup microphone during Audyssey MultEQ Room Correction and Speaker Setup, unless you want to cancel the setup.

6 Place the setup microphone at the next position, and then press ENTER.

Audyssey MultEQ performs more measurements. This takes a few minutes.

7 When prompted, repeat step 6.

8 Use q/wto select an option, and then press

ENTER.

MultEQ: Auto Setup

	- - Review Speaker Configuration - -
Subwoofer	Yes
Front	40Hz	TV
Center	40Hz
Surround	100Hz
Front Wide	None
Front High	100Hz
Surr Back	120Hz
Surr Back Ch	2ch

Save

Cancel

The options are:

`Save:

Save the calculated settings and exit

Audyssey MultEQ Room Correction and

Speaker Setup.

`Cancel:

Cancel Audyssey MultEQ Room Correction and Speaker Setup.

Note

•You can view the calculated settings for the speaker con- figuration, speaker distances, and speaker levels by using e/r.

9 Disconnect the speaker setup microphone.

Note

•When Audyssey MultEQ Room Correction and Speaker Setup is complete, the “Equalizer” will be set to “Audyssey” (➔ 49). The Audyssey indicator will light (➔ 9).

•You can cancel Audyssey MultEQ Room Correction and Speaker Setup at any point in this procedure simply by discon- necting the setup microphone.

•Do not connect or disconnect any speakers during Audyssey MultEQ Room Correction and Speaker Setup.

•If the AV receiver is muted, it will be unmuted automatically when Audyssey MultEQ Room Correction and Speaker Setup starts.

•Changes to the room after Audyssey MultEQ Room Correction and Speaker Setup requires you run Audyssey MultEQ Room Correction and Speaker Setup again, as room EQ characteristics may have changed.

Error Messages

While Audyssey MultEQ Room Correction and Speaker Setup is in progress, one of the error messages below may appear.

MultEQ: Auto Setup

Ambient noise is too high.

Retry

Cancel

Error message

The options are:

`Retry:

Try again.

`Cancel:

Cancel Audyssey MultEQ Room Correction and Speaker Setup.

• Ambient noise is too high.

The background noise is too loud. Remove the source of the noise and try again.

• Speaker Matching Error!

The number of speakers detected was different from that of the first measurement. Check the speaker con- nection.

• Writing Error!

This message appears if saving fails. Try saving again. If this message appears after 2 or 3 attempts, contact your Onkyo dealer.

• Speaker Detect Error

This message appears if a speaker is not detected. “No” means that no speaker was detected.

Tip

• See “Speaker Configuration” for appropriate settings (➔ 13).

En

30