Onkyo TX-NR1008 instruction manual Connecting the Speaker Cables, Screw-typespeaker terminals

•Don’t connect more than one cable to each speaker terminal. Doing so may damage the AV receiver.

•Don’t connect one speaker to several terminals.

Connecting the Speaker Cables

Screw-type speaker terminals

Strip 1/2" to 5/8" (12 to 15 mm) of	1/2" to 5/8"(12 to 15 mm)
insulation from the ends of the
speaker cables, and twist the bare
wires tightly, as shown.

Using Banana Plugs (North American models)

•If you are using banana plugs, tighten the speaker terminal before inserting the banana plug.

•Do not insert the speaker code directly into the center hole of the speaker terminal.

The following illustration shows which speaker should be connected to each pair of terminals. If you’re using only one surround back speaker, connect it to the SURR BACK L terminals.

Front high

Front wide

Front wide

Front high

right

right

Front right

Front left

left

left

Center

speaker

speaker

speaker

speaker

speaker

speaker

speaker

Surround	Surround	Surround	Surround
right	back right	back left	left
speaker	speaker	speaker	speaker

En

14