Audiovox FPE3707HR manual Memorizing the Channels, Selecting the TV Source, Auto Channel Search

Memorizing the Channels

When the TV powers on for the first time after purchase, the initial auto channel search is invoked.

This unit can automatically find all channels available through antenna or cable inputs, and store them in memory.

Note: Be sure to select the TV input (refer to <Selecting Input Source Signal> section on previous page) before

operation.

Selecting the TV Source

Before your TV can memorize the available channels, you must specify the type of signal source that is connected to the unit. (i.e., an antenna or cable system)

1 In full screen mode, press MENU to display the main menu.

2 Press 4or3 to display CHANNEL SETUP menu page, press 6 to enter.

3 Press 6or 5 to select TV Source item, press 3or4 to select AIR or CABLE.

Select AIR if using antenna.

Select CABLE if using cable.

Auto Channel Search

If TV Source is set to AIR: highlight Auto Search in the CHANNEL SETUP menu and then press 4or 3 to begin the auto channel search, the unit will automatically search for all available TV/DTV

program.

If TV Source is set to CABLE: highlight Auto Search in the

CHANNEL SETUP
TV Source	AIR
Current Channel	2-1
Channel Label	WGBH-
Channel Skip	OFF
Favorite Channel	OFF
Auto Search	> > >
Input Select	> > >
Signal Strength

CHANNEL SETUP
TV Source	AIR
Current Channel	2-1
Channel Label	WGBH-
Channel Skip	OFF
Favorite Channel	OFF
Auto Search	> > >
Input Select	> > >
Signal Strength

CHANNEL SETUP menu and then press 4or 3, now a Channel Scan Source window opens up. Use 4or 3to select one of STD, HRC, IRC and then press OK to begin the auto channel search, the unit will automatically search for all available CATV/CADTV program.

Note:

Channel Scan Source

STD HRC IRC

•If you want to stop the auto-search, press MENU button.

•Select one of Cable STD/HRC/IRC according to your local area's cable system, normally please select STD.

Channel Skip

After setting channels into memory, you can skip unnecessary channels so that only the channels you want to watch are selected with Channel up/down buttons.

1 Navigate to the CHANNEL SETUP menu.

2 Highlight Current Channel item, use 3or4 to select an unwanted channel.

3 Highlight Channel Skip item, use 3or4to set ON.

CHANNEL SETUP
TV Source	AIR
Current Channel	2-1
Channel Label	WGBH-
Channel Skip	ON
Favorite Channel	OFF
Auto Search	> > >
Input Select	> > >
Signal Strength

4 If you want to skip other unwanted channels, repeat the above steps.

5 Press EXIT button to exit.

Now when you use CH+/- buttons to cycle among the channels, the skipped channels can not be selected.

20