Installation, Removing the Base Stand | Audiovox FPE3208 guide

INSTALLATION

REMOVING THE BASE STAND

WARNING: The LCD display is very fragile, and must be protected at all times when removing the base stand. Be sure that no hard or sharp objects, or anything that could scratch or damage the LCD display, come in contact with it. Do NOT place pressure on the rear of the unit at anytime because the screen could crack.

1.Disconnect any cables or cords connected to the unit.

2.Lay the unit down on a flat surface, so the back side is facing up, making sure to place a soft cushioned material (such as a blanket or thick piece of foam) beneath the screen.

3.Remove the 8 screws and then remove the BASE STAND from the unit.

MOUNTING ON THE WALL

This unit is VESA-compliant, and is designed to be wall-mounted with a VESA-compliant 7 7/8” x 7 7/8” (200mm x 200mm) mounting kit designed for flat-panel TVs (sold separately). Mount this unit according to the directions included with the mounting kit.

NOTE

Remove the base stand before mounting the unit on the wall.

7 7/8”

Fourmounting

holes

E - 13

PLV36320CS11_IB_Eng_1-13.pmd

13/09/2007, 17:27