USING THE TV
Connect an antenna or CATV cable or Satellite system to the TV antenna terminal before searching TV channels.
Searching for TV channels automatically
(Only appears to the first time Power ON)
1.Connect the TV antenna.
2.Connect the AC adapter and AC cord.
3.Press the 
/ ON button to turn on the unit.
4.Press the ENTER button.
5.Press the 
or 
button to select “Air” or “CATV”, then press the ENTER button to start auto scan.
6.The unit will immediately search all channels for those with adequate signal strength and store those channels with signals in memory. The unit will take a short minutes to finish auto scan and aftter this is completed, the unit will switch to the first channel found.
PROCEED WITH AUTO SCAN?
NOYES
: SELECT
“ENTER” : CONFIRM
PLEASE SELECT ANTENNA TYPE.
AIRCATV
: SELECT
“ENTER” : CONFIRM
Manual searching for TV channels
1. | Press the TV MENU button, then press the | button to TV |
|
|
|
|
| |
| CHANNEL SETTING. |
|
|
| RF CH | 13 |
| |
2. | Press the | button to select ANTENNA. Use the | or button to |
|
| Found | 0 |
|
| select AIR or CATV. |
|
|
|
|
|
| |
3. | Use the | button to select Auto Scan. |
|
|
|
|
|
|
|
|
|
|
|
| |||
4. | Press the ENTER button to enter sub menu of Auto Scan. | Press “MENU” To Exit Auto Scan | ||||||
5.Use the 
button to select “Start to Scan” in the sub menu.
6.Press the ENTER button to start the search for TV channels.
7.The screen will show the first received channel when auto search is completed.
Watching television
Viewing a television station after the auto/manual search for channels.
1.Press the FUNCTION button to TV mode.
2.Press the 
CH+ or 
CH- button to select a channel, or press the number button on the remote to select the channel you want to watch.
•For channels 1 to 9, enter
•For channels 10 to 99, enter
•For channels 100 or over, enter
NOTE
•When a channel is selected, the channel number is displayed on the top right corner of the screen. This number will disappear after a few seconds.
ATSC TV mode:
Press the DISPLAY button, the upper window will pop up, then press the DISPLAY button again, the lower window will pop up. Press the DISPLAY button once to exit.
NTSC TV mode:
Press the DISPLAY button, the upper window will pop up, then press the DISPLAY button once to exit.
| ATSC data information | Signal | Rating | |||
|
| (only ATSC) |
| |||
|
| Audio | strength information | |||
Time information |
| |||||
information | (only ATSC) |
| ||||
Position no. |
|
|
| |||
|
|
|
|
|
| |
ATSC data | 2.3 | Xxxxxxx Xxxx |
|
|
| |
|
|
|
|
|
| |
information |
| AUDIO 1/1(L+R) |
| FTA | ||
(only ATSC) |
|
|
|
|
|
|
2007/01/31 07:38
Xxxx xx xxxxxx xx xxxx xx xxxxxxxx x xxxx xxxxx xxx xx xxx
xxxxxxxxxxxxx xxxx xxxxx xx x xxxxx xxx xxxxxx x xxxxxx xxx xxxxxx xx xxxx xx xxxxxxxx x xxxx xxxxx xxx xx xxx xxxxxxxxxxx xx xxxx xxxxx xx x xxxxx xxx xxxxxx x xxxxxx xxx
E 12