Beko 40WLU550FHID manual How To Connect CI Common Interface Card, To Insert a CI Card

Page 31

9.8- How To Connect CI (Common Interface) Card

1- To view the scrambled (pay) services in digital TV mode.

TO INSERT A CI CARD

(NOTE: The card on its own cannot be used on this TV. A CAM (Conditional Access Module) must be purchased and the card inserted into the CAM. The CAM / card holder is then inserted into the CI slot on the TV.)

Insert the CAM / holder card into the slot in the direction of the arrow until it is fully located.

Side or Rear view of TV

TO REMOVE A CI CARD

When removing the CI card, make sure you pull out the CAM complete with the card fitted.

This function enables you to watch the scrambled services (pay services) in some channels. If you remove the CI Module, you can only watch the available non scrambled digital programmes.

2- Press the Standby button on the remote to turn on the TV.

3- Press the INPUT button on the remote to display the Source List. Use the Up/ Down buttons to select DTV, and press the OK button.

4- If the CI card is inserted properly, the CI MODULE will briefly be displayed on screen, The contents are dependent on the CAM provider in you country.

29

Image 31

Contents Operation Instructions Table of Contents Important Information Cleaning the screen and cabinetDisposing of your TV at the end of service life Superior features of your integrated digital televisionChanging the plug Special Features Features of your new televisionPlease consider all warnings Important Safety InstructionsPower connections Please observeFire Never operate yourCause permanent loss of hearing Batteries. There is the risk of explosion Batteries Aerial connection Powering on your TV and the initial useInitial power on and performing settings StartTV Control Panel Your new televisionRear and Side External Connections Digital Mode Only Remote ControlTV controls Performing the initial power-on settingsOr finish the searching process by pressing the Menu button Turning on the TV and Setting the ChannelsPerforming Digital Tunings Automatic Tuning of Channels and Storing in the MemoryFirst Time Installation Manual tuning of channels and storing in the memoryPress Menu Select Setup Electronic TV Guide EPG FAV button on your remote controlProgram Table Creating favorite channels listSelect Subtitling Language Digital FeaturesLanguage Settings Access ControlPerforming Analog Tunings Simply press the Exit button Fine TuningIf you do not know the channel number Would like to have the channel stored. IfTo name the channels Switching the locations of the stored channelsDeleting a stored channel Skipping a stored channelSound Menu Settings Settings of Your New TelevisionPicture Menu Settings Picture Format BacklightMpeg NR Picture SmartFeatures Menu Settings Other Picture Features Teletext Fastext Temporary TV Picture UpdateQuestion Answer Button Reveal ClockExternal Equipment Connections Connecting an external equipment via Scart connectionHeadphone Connection Connecting external equipment via Ypbpr connection Device connected using the Phono input, selectAV To watch the picture of the broadcast Hdcp HD Copy Protection Connecting an external equipment via Hdmi connectionFull HD PC Connection Switching to the PC modePC Setting PC VGA connectionTo Insert a CI Card How To Connect CI Common Interface CardHelp and tips Failure Possible cause SolutionGeneral technical specifications Technical specifications chartMain UK Transmitter Stations What is covered? Guarantee TelevisionHOW to Obtain Service Y1A.801