MON170CL Instruction Manual Installation | EN 8 |
|
|
5.2Desktop Installation
The MON170CL monitor is delivered with a
The monitor end of the power cord plugs into the power connector at the power adapter. The monitor automatically adjust to either power input voltage.
Photo C
5.2.1 Power Supply Installation
1.Turning the locking clip a quarter turn to unlock the base, as shown in photo A.
2.Lose the clips on the bottom of the base and fold the base unit up, as shown in photo B.
3.Connect the bayonet connector from the power supply to the power input connector on the rear side of the LCD panel, as shown in photo C.
5.3Connecting the Composite Video (CVBS) Input Signal to the Monitor
There is one (1) RCA connector located on the rear of the monitor for composite video input (Figure 2); also included is one (1) RCA Jack to BNC converter (included with the MON170CL) to connect BNC cable line, as shown in photo D and E.
Photo A
Photo D
Photo B
Photo E
Bosch Security Systems 6 July 2005