Clarion TB731P Troubleshooting, Selecting VTR system NTSC/PAL/ Auto, Watching a external device

TV Mode Operations

English

Owner’s manual

Selecting VTR system (NTSC/PAL/ AUTO)

1.Display the adjustment menu as described in the section, “Selecting the adjustment menu”.

VTR N/PNTSC PAL AUTO

[ AUDIO OUT ]

[ TV AREA ]

ADJ 2

2. Press the [a] or [d] button to select

Changing the TV reception area (TB731P only)

∗ The factory default setting is “OTHERS”.

1.Display the adjustment menu as described in the section, “Selecting the adjustment menu”.

■ OTHERS ■

[ AUSTRALIA ]

[ NEW ZELAND ]

RTN TV AREA

English

Owner’s manual

NTSC, PAL or AUTO.

∗When [AUTO] is selected, automatic switching between NTSC and PAL may not occur properly. In such cases, use manual selection.

∗Press the [ADJ] button to return to the normal screen mode.

∗The factory default setting is “AUTO”.

Setting the audio output sound level

You can adjust an output sound level of audio output terminal (RCA L/R).

1.Display the adjustment menu as described in the section, “Selectiong the adjustment menu”.

[	VTR N/P	]
				LOW
	AUDIO OUT		HI
[	TV AREA	]

2.Press the [d] button to display a TV area selecting screen.

3.Press the [w] or [z] button to select a desired mode and set it.

∗Press the [BND] button when all adjustments have been made to return to the adjustment menu screen.

Press the [ADJ] button to return to the normal screen mode.

∗Any station preset memories are lost when the reception area is changed.

Watching a external device

Refer to the Instruction Manual of the unit concerned for details on operating the external device connected.

Press the [BND] button to select VTR (External Device).

Each time the [BND] button is pressed, the setting is switched in the sequence shown below.

TV1 TV2 VTR1 VTR2

8. TROUBLESHOOTING

■ If you think that something has gone wrong with your unit, check out the following points

before requesting servicing.

	Problem	Cause		Measure
	Power does not	Fuse is blown.	Replace with a fuse of the same amperage. If the
	turn on.		fuse blows again, consult your store of purchase.
	(No sound is
	produced.)	Incorrect wiring.	Consult your store of purchase.
	Nothing happens	The microprocessor has	Turn off the power, then press the reset button for
	when buttons are	malfunctioned due to noise,	about 2 seconds with a thin rod.
	pressed.	etc.	Note: When the reset button is pressed, turn off the
	Display is not		ACC power.
	accurate.
GENERAL
				The Reset button
			∗ When the reset button is pressed, frequencies of
			TV, etc. stored in memory are cleared.
	The remote	Direct rays of the sun fall on	When direct rays of the sun fall on the light-receptive
	controller does	the light-receptive part of the	part of the remote controller, it may not work.
	not work.	remote controller.
		The batteries of the remote	Check the batteries of the remote controller unit.
		controller unit are dead or
		there is no battery in the
		remote controller unit.

ADJ 2

2.Press the [a] or [d] button to select a desired mode and set it.

3.Press the [ADJ] button to return to the

normal screen mode.

∗ The factory default setting is “HI”.

16 TB731P/TB732P/TB733W TB731P/TB732P/TB733W 17