Bosch Appliances MON150CL Connecting the Analog VGA Signal To the Monitor, Ventilation

MON150CL Instruction Manual Operation EN 9

5.6Connecting the Analog VGA Signal

to the Monitor

There is one (1) 15-pin D-sub connector (Figure 4) for one analog VGA input. Refer to Figure 2, item B.

Figure 4: Analog VGA Connector

5.7Ventilation

To prevent overheating, ensure that the ventilation openings on the rear of the monitor are not covered.

6.0OPERATION

6.1Front Panel Controls (Figure 1)

AUTO (Input)	Press this button to display the input
	signal which is selected on the screen
+/-	Press the ‘+’ or ‘-’ button to move the
	cursor to the targeted parameter in the
	OSD main menu. Press the ‘+’ or ‘-’
	button to adjust the value of the selected
	parameter in the OSD sub-menu.
MENU	Press this button to open the main OSD
	menu. Use this button to confirm a value
	for a parameter in the OSD Menu.
Power LED	Power on (Green)
Identification	Stand by (Amber)
POWER	Press this button to turn on or turn off
	the monitor

6.2On-screen Display (OSD) Menu

6.2.1 Video Setting (CVBS/S-VIDEO)

Saturation

1.Press Menu to open the OSD Main menu

2.Press the ‘+’ or ‘-’ button to highlight an option, then press Menu to modify the value of the option

Contrast Adjusts the contrast value

(0-100)

Brightness Adjusts the brightness value (0-100)

Tint	Adjusts the tint value (NTSC only)
	(0-100)

Saturation Adjusts the color value (0-100)

Volume Adjusts the volume (0-31)

Exit Exits the OSD menu

6.2.2 Colour Setting (RGB / VGA)

Colour Setting

1.Press Menu to open the OSD Main menu

2.Press the ‘+’ or ‘-’ button to highlight an option, then press Menu to modify the value of the option

Contrast Adjusts the contrast value

(0-100)

Brightness Adjusts the brightness value (0-100)

Gamma Correct

Opens an optimum Gamma curve (0/1/2/3)

Colour Adjust

Opens the color menu. Select a color then press Menu to adjust the value of the selected color.

Exit Exits the Colour OSD menu setting

Bosch Security Systems May 20, 2005