061506_OD LCD Manual 6/15/06 4:57 PM Page 2
ON/OFF Reverse
Maintain 
Forward
Powering ON (Some Models)
The master power switch is located on the rear of the shredder head. When the switch is turned on, the LCD displays all of the operating functions and gives a beep (See figure on left). Two sec- onds after the characters are shown, the display clears and enters the standby mode.
ON Mode
When pressing the ON/OFF button for more that three seconds, the LCD shows AUTO and enters AUTO mode. In the AUTO shredding mode, the shredder stands ready to shred paper, If there is any paper stuck at the throat in the shredder, the shredder will automatically shred the paper. The shredder will stop after the paper is completely shredded.
ON/OFF Reverse
Maintain 
ON/OFF Reverse
Maintain 
Forward
Forward
OFF Mode
When pressing the ON/OFF button for more that three seconds, the shredder will beep once and shut off all functions, entering into standby mode, the LCD will turn off. If you wish to restart, press and hold ON/OFF button for more than three seconds to start.
REVERSE Mode
When pressing the REVERSE button, LCD shows the character of REVERSE and the motor enters the REVERSE mode. Press and hold the REVERSE button in order to keep the motor running in reverse. When the REVERSE button is released, the motor will stop. If there is any paper left at the throat, the shredder will enter into the AUTO shredding mode and the display will show AUTO.
REVERSE Mode, when shredding in AUTO mode During forward shredding, if the REVERSE button is pressed, the motor will stop immediately. After three seconds, the motor starts reversing while the LCD shows REVERSE. Pressing the REVERSE button will keep the motor running. The shredder will not stop until the button is released. After the motor stops, if there is still paper remaining in the throat, the shredder will resume AUTO shredding and the LCD will display AUTO.
2