Attaching Tilt Brackets to Screen using Baffled Fastener Pack
WARNING
•Tighten screws so adapter brackets are firmly attached. Do not tighten with excessive force. Overtightening can cause stress damage to screws, greatly reducing their holding power and possibly causing screw heads to become detached. Tighten to 40 in. • lb (4.5 N.M.) maximum torque.
•If screws don't get three complete turns in the screen inserts or if screws bottom out and bracket is still not tightly secured, damage may occur to screen or product may fail.
2 | To prevent scratching the screen, set a cloth on a flat, level surface that will support the weight of the screen. Place screen |
face side down. Refer to screen manufacturers instructions or customer service, for removing any knobs, base, cover, or |
screw(s) on the back of the screen to prepare mounting. These need to be removed to allow the adapter brackets to be attached. Select the small, medium, large or extra large screws from the baffled fastener pack then attach adapter brackets to screen following figure 2.1 or 2.2.
NOTE: Be sure to attach adapter brackets with handles facing outward as shown below.
NOTE: Top and bottom mounting holes on screen must be used for attaching brackets. Middle holes should also be used where the fasteners and screens allow. Verify that all holes are properly aligned, and then tighten screws using a phillips screwdriver.
CENTER BRACKETS VERTICALLY ON BACK OF SCREEN
HANDLESFACE |
OUT |
BB |
X
CC
X
Note: "X" dimensions should be equal.
NOTE: For flat back screens proceed to step
6 of 24 | ISSUED: |
Visit Peerless website at www.peerlessmounts.com | For customer care call |