Peerless Industries HLG452-002-Q10 manual Attach lock-down plate to display base bottom using

3	Attach lock-down plate to display base bottom using
	screws provided by manufacturer. Refer to page three

for lock-down plate/ display base stand hole pattern. NOTE: Remove existing rubber feet from display base that interfere with the lock-down plate.

DISPLAY BASE STAND

4	Hand tighten slope nut (D) through 1/4-20 x 1 3/4"
	screw bolt (B) until snug against bottom of desktop

surface. Thread another slope nut (D) upside-down, about two turns from first slope nut (D). Insert a open box wrench between both slope nuts (D) and tighten. NOTE: Avoid jamming both slope nuts (D) together, doing so may make it difficult to remove slope nut used for tightening first slope nut (D). After slope nut is secure remove bottom slope nut and add plastic cap (C) as shown in figure 4.2. Repeat with remaining 1/4-20 x 1 3/4" screw bolt (B).

RUBBERFEET BOTTOM OF DESKTOP

SCREWS SUPPLIED BY

MANUFACTURER

NOTE: Display base stand and mounting hole locations may appear different than illustrated.

A B D

TIGHTENING

SLOPE NUT

FIG 4.1

B

C

FIG 4.2

4 of 6	ISSUED: 09-04-08 SHEET #: 090-9150-3 10-05-09
Visit the Peerless Web Site at www.peerlessmounts.com	For customer care call 1-800-729-0307 or 708-865-8870.