Navi Bars
Maintenance folder
System Information
When you enter the Maintenance folder you find general informa- tion about which hardware and software version your Mediamaster is running on.
Reinstall
Use this option only if you have to start the complete installation procedure from scratch. If you continue from here, all your previ- ous settings, access code and favourite channels etc. will be erased!
If you do not want to perform a reinstallation you can leave this menu when the warning is displayed by pressing “back”.
SW update
Your Mediamaster will advise you from time to time of any new software upgrades using information sent by TV broadcasters through your aerial.
This will appear as a message on your tv screen asking you to press ok to start the download. You are strongly advised to accept the download as this might enable you to receive the new features and or services that may be available to you . You can choose to post- pone the download for a more convenient time by pressing the back button. The message will appear again provided that the software is still broadcast.
Note : These messages will only appear if your Mediamaster has been switched on from Standby.
It is advisable to put you Mediamaster into standby when not in use.
After downloading of a new software version, all your previous set- tings, access code and favourite channels etc. will be erased! IMPORTANT! The updating may take a while.
NEVER turn off the Mediamaster, never use the remote control or disconnect the antenna cable during the download procedure! This will damage the software and the receiver will have to be sent in for service!
GB 20