Connecting the Mediamaster
The box for your Mediamaster should contain the following items:
•The Mediamaster
•Remote control with 2 AAA batteries
•SCART cable (fully connected; 1,0 metre)
•RF cable
• | User Guide with software license agreement ( | SCART cable | RF cable | |
• | Separate power supply. | |||
|
|
Remote control | Power supply |
About the SCART socket
The rear panel of the Mediamaster is equipped with a SCART socket |
|
(see picture.) When you connect other devices to this socket, always |
|
use a fully connected SCART cable (as the one supplied.) There are |
|
SCART cables available which do not have all the pins connected. The |
|
picture quality could be reduced if you use them. | SCART socket |
Preparing the remote control
•Remove the cover on the battery compartment at the bottom of the remote control.
•Insert the 2 AAA; 1,5 V batteries, as shown in the diagram, tak- ing care to observe the + and - markings indicated inside.
•Replace the cover.
About digital transmission
Digital Radio and TV signals can be blocked by buildings, mountains and the terrain. Depending on if the receiver is located in a valley, behind a mountain or in a concrete building, the quality of recep- tion may vary considerably.
As with most other transmissions, bad weather does affect the re- ception quality.
GB 6