Resetting the Remote

ADVANCED FUNCTIONS

It isn’t possible to “edit” a command within a macro. However, you may erase the macro as follows:

1.Simultaneously press and hold the Mute Button and the Macro Button containing the macro until the Program LED flashes.

2.Press the Surround Button to erase the macro.

Here are two macros that you may find useful when listening to an iPod docked in The Bridge:

The purpose of the first macro is to access the DMP SETTING menu while listening to The Bridge with one button press:

1.Simultaneously press and hold the M1(or other unused) Macro Button and the Mute Button until the Program LED flashes.

2.Press the AVR Button (the first command switches the remote to AVR mode).

3.Press the OSD Button (the second command activates the on-screen menu system).

4.Press the Set Button (the third command selects the INPUT SETUP menu; this macro assumes the current source is The Bridge).

5.Press the ¤ Button three times (the fourth, fifth and sixth com- mands navigate to the GO TO DMP SETTING line).

6.Press the Set Button again (the seventh command selects the DMP SETTING menu).

7.Press the Sleep Button to end the programming process. You have now programmed the first macro, which will display the DMP SET- TING menu after you have selected The Bridge as your source input.

After you have made your selections in the DMP SETTING menu, such as turning on Repeat Playback or Shuffle mode, the second macro enables you to exit the on-screen menu system and return the remote to The Bridge mode, again with just one button press.

1.Simultaneously press and hold the M2 (or other unused) Macro Button and the Mute Button until the Program LED flashes.

2.Press the OSD Button (the first command exits the on-screen menu system; this macro assumes that you have not let the OSD time out).

3.Press the Tape/The Bridge Input Selector twice (the second and third commands switch the selector to The Bridge mode and select The Bridge as the source). This step is required even if you already switched the selector’s mode before programming the macro.

4.Press the Sleep Button to end the programming process. You have now programmed the second macro, which may be used after run- ning the first macro to exit the OSD system quickly and return the remote’s operation to The Bridge.

To reset the remote to its factory defaults, simultaneously press and hold any Input Selector and the “0” Numeric Key. When the LED flashes amber, enter the code “333”. When the green LED goes out, the remote will have been fully reset.