Rear Panel Connections, ∞ S-Video Output

Rear Panel Connections

MODEL NO. DVD 22

¡Optical Digital Output ™ Coaxial Digital Output £ Analog Audio Outputs ¢ Composite Video Output

¡Optical Digital Output: Connect this jack to the optical digital input of an A/V receiver or surround processor for Dolby Digital, DTS or PCM audio playback.

™Coaxial Digital Output: Connect this jack to the coaxial digital input of an A/V receiver or surround processor for Dolby Digital, DTS or PCM audio playback.

NOTE: The coaxial digital output should only be connected to a digital input. Even though it is the same RCA-type connector as standard ana- log audio connections, DO NOT connect it to a conventional analog input jack.

£Analog Audio Outputs: Connect these jacks to the analog audio input on an A/V receiver or surround processor for analog audio playback.

¢Composite Video Output: Connect this jack to the video input on a television or video projector, or to a video input on an A/V receiver or processor if you are using that type of device for video input switching.

∞S-Video Output

§Component Video Outputs ¶ Scart TV Output

• Remote Control Output

∞S-Video Output: Connect this jack to the S-Video input on a television or video projector, or to an S-Video input on an A/V receiver or processor if you are using that type of device for S-Video input switching.

§Component Video Outputs: These out- puts carry the component video signals for con- nection to display monitors with component video inputs. For standard analog TV's or projec- tors with inputs marked Y/Pr/Pb or Y/Cr/Cb, con- nect these outputs to the corresponding inputs. If you have a high-definition television or projec- tor that is compatible with high scan rate pro- gressive video, connect these jacks to the “HD Component” inputs. Note that if you are using a progressive scan display device, then ”Progressive” must be selected in the Video Set- up Menu in order to take advantage of the pro- gressive scan circuitry. See page 17 for more information on progressive scan video.

IMPORTANT: These jacks should NOT be con- nected to standard composite video inputs.

¶SCART OUT (TV): If your TV has a SCART socket, you can connect a SCART cable to your TV and to your DVD Player for improved video quality. The SCART cable carries both audio and video. You can select Composite Video or RGB video for that SCART connector’s video output signal.

ªRemote Control Input ‚ AC Power Cord

•Remote Control Output: Connect this jack to the infrared (IR) input jack of another compatible Harman Kardon remote controlled product to have the built-in Remote Sensor on the DVD provide IR signals to other compatible products.

ªRemote Control Input: Connect the out- put of a remote infrared sensor, or the remote control output of another compatible Harman Kardon product, to this jack. This will enable the remote control to operate even when the front panel Remote Sensor on the DVD is blocked. This jack may also be used with compatible IR remote control-based automation systems.

‚AC Power Cord: Connect this plug to an AC outlet. If the outlet is controlled by a switch, make certain that it is in the ON position.

Note: You’ll find more details about all Audio/Video connections under Setup and Connections on the following pages.

Harman-Kardon DVD22B owner manual Rear Panel Connections, ∞ S-Video Output, Remote Control Output