Q-See MODEL QC40196, MODEL QC40198 user manual Alarms, Alarm Input, Running PTZ Functions

RUNNING PTZ FUNCTIONS

Clicking on the Page Switch button in the PTZ Control Panel (Picture 6-5) will switch to a new window (Picture 6-11) which allows you to activate the functions created above as well as the Auto Pan and Flip functions.

Enter the number of the function you wish to activate and select the function button to run that function.

ALARMS CHAPTER 7

This DVR features connections for external alarms – both input and output. When an event is detected the system can notify local users or send notification to a monitoring service. At the same time, the system can accept signals from motion detectors, smoke detectors or other alarms and begin recording based on that input and your settings.

You will need to have the manual for your alarm(s) handy to ensure the proper settings within the DVR.

In addition, there are other functions that can be engaged in this window.

AutoPan - This will cause the camera to	PICTURE 6-11
automatically rotate.

Flip - Most PTZ cameras have a mechanical stop which will prevent the camera from rotating a full 360°. If the camera is tracking someone or some thing and it reaches this stop, pressing Flip will bring the camera around the other

7.1 ALARM INPUT

When attaching alarms, the following criteria must be met:

1.The alarm input must be grounded.

2.A grounding signal is required for the alarm input

3.When connecting the DVR to another device - including another DVR - through the alarm input, a relay should be used to separate them.

ALARM IN

	1		2	CNTRL	A B
NO C		NO C		12V

CHAPTER 7

direction to continue tracking. Some PTZ cameras have “E-flip” which will do this automatically.

Page Switch - returns you to the PTZ Control Panel (Picture 6-5)

Reset - This ends the currently running function.

	1	2	3	4	5	6	7	8
				PICTURE 7-1
Parameter	Grounding Alarm
	Ground line
Alarm Input	1, 2, …, 8 becomes valid in low voltage.
1-NO C	Two NO activation outputs.
2-NO C
CTRL 12V	Controls the power output

You need to close the device power to cancel the alarm.

ALARMS

54 55