CTM-MS2 Installation
1.Using a (commercially available) wood stud finder, locate the 16" or 24" stud centers behind the wall (Figure 12).
2.Once found, make a pencil marking on the center of the wood studs (Figure 13).
NOTE: The wall plates have 16" and 24" mounting slot positions.
3.Place the wall plate to the reference line and mark the nine (9) lag bolt mounting points through the wall plate slots on the wall.
Wood Stud Finder (Commercially available)
Mark the wall and the center of the wood studs.
16"
16"
Measure and mark the viewing height desired on the
wall.
Wood studs behind the wall structure.
Figure 12 | Figure 13 |
NOTE: Although not depicted in the illustrations shown above, the width of this wall mount will encompass four wall studs (three studs if 24” apart).
Page - 12 - | Installation Manual |