Service jack

Preparation for using your new TV

Connecting your TV

Caution: Do not plug in the TV until you have finished connecting all of your equipments.

Connecting to an antenna

To enjoy the televison antenna (not supplied). subscriber of your local as shown below.

program transmitted by your IocaITVstation, you need an indoor or outdoor An outdoor antenna is necessary for a perfect picture quality. If you are a CATV net, the outdoor or indoor antenna is not needed. Connect the equipments

Side Panel

Plug (not supplied)

COAXIAL CABLE (75Q)

ANT 750

TWIN-LEAD FEEDER (300£/)

The signal comes from: An outdoor antenna An indoor antenna CATV net

Adaptor (not suppl_)j__

Loosen the screw 2.Insert the feeder in 3.Tighten the screw _

Connecting to A/V equipments

To enjoy the multimedia features, you can connect your TV to A/V equipments such as VCD, DVD, STB, Satellite receiver, Camcorder, Audio amplifier etc., and select signal source using your remote control.

Connect RCA audio cables to"R-AUDIO - L" on the rear of your set and the other ends to corresponding audio out connectors on the A/V device.

NOTE: 1. Headphones are not included.

2.No sound will be heard from the main unit speakers whena headphone mini-plug is connected into the headphone jack.

Connector for service only (do not connect any equipment here).

Connecting component devices (DVD/PVR)

Connect Component video and audio cables to Component inputs ("PR/CR", "PB/CB", "Y") on the rear of your set and the other ends to corresponding component video out connectors on the PVR or DVD.

The Y, PB/CB and PR/CR" connectors on your component devices (PVR or DVD) are sometimes labeled Y, B-Y and R-Y or Y, CB and CR (Colors for inputs and cables must correspond to both devices).

NOTE: Some devices such as a PVR or DVD players require 'Component/YPBPR' signal to be set via output in the devices settings. Please consult your device user manual for instructions.