Digimate DGL3704M manual Do not attempt to service the Display yourself

Page 2

TO PREVENT POSSIBLE DANGER, ELECTRIC SHOCK, AND OTHER INJURIES WHEN HANDLING YOUR DISPLAY, PLEASE BE AWARE ALL WARNINGS AND SAFETY PRECAUTIONS CONTAINED AS BELOW.

Never Insert anything into DISPLAY!!

¾Do not insert anything through the openings in the unit, where they can touch dangerous voltage points or damage parts.

¾Never spill liquid of any kind on the Display

Do not attempt to service the DISPLAY yourself!!

¾Opening or removing covers may expose you to dangerous voltages and other hazards. Refer all servicing to qualified service personnel.

Do not touch your DISPLAY and antenna during thunderstorms!!

Unplug the Display during thunderstorms or if it is not going to be used for an extended period.

¾Failure to do so may result in electric shock or fire.

ATTENTION!!

¾Unplug the DISPLAY from the wall socket before cleaning.

¾Use a damp cloth for cleaning.

¾Do not use liquid or aerosol cleaners.

Well ventilation is required!!

To ensure reliable operation of the product and to protect it from overheating, the ventilation must not be blocked or covered.

¾The monitor should be away from the wall 10 cm above, and always keep the vent clean.

¾Do not place your DISPLAY in a cramped and inadequately ventilated place.

¾Avoid your DISPLAY to be placed upside down in any time.

Note:

1.Read all safety and operating instructions before operating your new Display.

To ensure good ventilation, a distance of more than 10cm shall be maintained between the Display and any other furniture.

2.For this Display set, the operating temperature is 5 ~ 35 °C, storage temperature is 0 ~ 60 °C

Image 2
Contents User’s Manual Do not attempt to service the Display yourself Canadian Doc Notice For Class B Computing Devices FCC Compliance StatementRadio Frequency Interference Statement Table of contents Power source for 37 AU Panel FeaturesStandard Accessories Getting StartTop Panel Buttons: Controls and FunctionsOperating the monitor Bottom view Rear Panel JacksSide view Remote Control Connecting the power cable Installing your DisplayConnecting the aerials Remote controlCh. Edit Channel Edit Quick InstallationAuto scan Basic Operation Main Menu There are seven SUB-MENUS in the main OSD Menu TV mode Press MenuPC mode DVI, VGA TV/PC Parameters Adjusting the TV settingColor Temp PC parameters Adjusting the picture setting TV ParametersPress Menu after adjustment is made Audio Settings In TV, Video, and PC modes Adjusting the audio setting Picture-In-Picture PIP structureSleep Timer General SettingsTV, Video, and PC modes Adjusting General Settings Deinterlace For U.S. area only CC Control Use remote controlParental Controls Closed captionMpaa rating ChipChip Lock TV PG Rating Parental Guideline TV-YTroubleshooting Cannot workSupported Timing Display Mode Analog / DigitalFrequency Modes Supported