Digimate DGL32 manual Getting Started, Rear Panel Jacks

Page 10

Rear View

Getting Started

 

 

REAR PANEL JACKS

Side View

1Y1Cb1Cr1 Connecting to the Video component1 output terminal of the video output device.

2Y1Cb1Cr1 Audio Audio input terminal connecting to the audio output terminal of the video output device.

3 Y2Pb2Pr2 Connecting to the Video component2 output terminal of the video output device.

4 Y2Pb2Pr2 Audio Audio input terminal connecting to the audio output terminal of the video output device.

5 S-videoY/C S-video input terminal connecting to the S-output terminal of the video output device.

6 S-video Audio Audio input terminal connecting to the audio output terminal of the video output device.

7Sub-wooferConnects the sub-woofer audio.

8

Video out

Video output terminal connecting to the input terminal of the video input device.

(The video output sources are only AV1, AV2, AV3 and TV)

 

 

9

Audio out

Audio output terminal connecting to the input terminal of the audio input device.

(The audio output sources are AV1, AV2, AV3 and TV)

 

 

10AV 1 inTo connect the AV1 source.

11AV 1 audio in To connect the audio out of AV1 source.

12AV 2 inTo connect the AV2 source.

13AV 2 audio in To connect the audio out of AV2 source.

14AV 3 audio in To connect the audio out of AV3 source.

15AV 3 inTo connect the AV3 source.

16Headphone To connect to headphone.

Bottom view

1PC AudioConnect this terminal to the sound output terminal of your PC or Notebook.

2 ANT

Connect the coaxial cable or antenna.

3D-subConnects to D-sub 15 pin analog output connector of the PC display card.

4DVI for PC Connects to DVI digital output connector of the PC display card.

5 AC in

Connect this terminal to the power cord supplied with Display, and a switch is attached

to turn on /off the power of unit.

 

Connect the power supply

ANT

Using ANT. Adapter included

Connect the cable or antenna

DVD

CAM

GAME

Use Y1Cb1Cr1/Y2Pb2Pr2, AV, or S-video to connect the VCR, DVD or the Video Game.

Audio cable connects to PC audio VGA cable connects to VGA card.

DVI cable connects to DVI card (if DVI cable is available)

9

Image 10
Contents User’s Manual Important Safeguards Power Sources Do not attempt to service the Display yourself FCC Compliance Statement Radio Frequency Interference StatementTable of contents Power source required AC 100 ~ 240 V 3.5A, 50 / 60 Hz FeaturesStandard Accessories Unpacking and Checking Package ContentsAntenna Connections Operating the monitor Location of ControlsFront Panel Buttons: Getting Started Rear Panel JacksRemote Control TV FunctionRemote Control Power supply connections Installing your DisplayConnecting the aerials Antenna Remote controlAuto scan Ch. Edit Channel EditBasic Operation PC mode DVI, VGA TV mode Press MenuMain Menu There are seven SUB-MENUS in the main OSD Menu TV/PC Parameters Adjusting the TV settingColor Temp PC parameters Adjusting the picture setting TV ParametersAdjusting the audio setting Audio SettingsTV, Video, and PC modes Picture-In-Picture PIP structureTV, Video, and PC modes Adjusting the general setting General SettingsSleep Timer Deinterlace MotionParental Controls CC Control Using remote controlUsing menu For U.S. area onlyUse menu Use remote controlChip Chip LockTV PG Rating Parental Guideline TV-YTroubleshooting Symptoms Check ItemsSupported Operation Mode Supported Timing