Digimate DGL32 manual FCC Compliance Statement, Radio Frequency Interference Statement

Page 5

CONFORMITY AND COMPLIANCE

FCC Compliance Statement

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a residential installation. This device generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this device does cause harmful interference to radio or television reception (this can be determined by turning, the device off and on), you are encouraged to try to correct the interference by one or more of the following measures:

*Reorient or relocate the receiving antenna.

*Increase the separation between the equipment and the receiver.

*Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

*Consult the dealer or an experienced radio/TV technician for help.

Caution:

To comply with the limits for an FCC Class B computing device, you should use the shielded signal cord and power cord supplied with this unit. The Federal Communication Commission warns that changes or modifications of the unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Radio Frequency Interference Statement

Warning:

This is a Class B product. In a domestic environment this product may cause radio interference in which case the user may be required to take adequate measures.

Canadian Doc Notice

For Class B Computing Devices

This digital apparatus does not exceed the Class B limits for radio noise emissions from digital apparatus as set out in the Radio Interference Regulation of the Canadian Department of Communications.

CE MARKING DECLARATION OF CONFORMITY

The LCD display complies with the requirements of related European standards, which include: Emission: EN 55022, EN 61000-3-2, EN-61000-3-3

Immunity: EN 50082-1

Safety: EN 60950 Low-Voltage Directive (73/23/EEC)

is a trademark of SRS Labs, Inc. WOW technology is incorporated under license from SRS Labs, Inc.

manufactured under license from BBE Sound, Inc.

4

Image 5
Contents User’s Manual Important Safeguards Power Sources Do not attempt to service the Display yourself Radio Frequency Interference Statement FCC Compliance StatementTable of contents Standard Accessories FeaturesPower source required AC 100 ~ 240 V 3.5A, 50 / 60 Hz Unpacking and Checking Package ContentsAntenna Connections Front Panel Buttons: Location of ControlsOperating the monitor Rear Panel Jacks Getting StartedTV Function Remote ControlRemote Control Connecting the aerials Antenna Installing your DisplayPower supply connections Remote controlCh. Edit Channel Edit Auto scanBasic Operation Main Menu There are seven SUB-MENUS in the main OSD Menu TV mode Press MenuPC mode DVI, VGA Color Temp PC parameters Adjusting the picture setting Adjusting the TV settingTV/PC Parameters TV ParametersTV, Video, and PC modes Audio SettingsAdjusting the audio setting PIP structure Picture-In-PictureSleep Timer General SettingsTV, Video, and PC modes Adjusting the general setting Motion DeinterlaceUsing menu CC Control Using remote controlParental Controls For U.S. area onlyChip Use remote controlUse menu Chip LockTV-Y TV PG Rating Parental GuidelineSymptoms Check Items TroubleshootingSupported Timing Supported Operation Mode