Garmin manual TR-1 Gold Owner’s Handheld Quick Reference, Mob

TR-1 Gold Owner’s Handheld Quick Reference

How to use Pattern Steering How to Change the Values of the Parameters

Press and Hold theButton. While holding the Setup but- ton down, press, select and light up the LED number to the correspond- ing pattern from the table below. Release the Setup button. To engage pattern steering press and release the corresponding button (Idle/Resume, or Bent Arrow Buttons, etc).

1	MOB	4	Step Turns	7	Orbits
2	Idle/Resume	5	Circles	8	Cloverleaf
3	Other/ Zig-Zags	6	Remote Steer	9	Search

1. Press and release the Setup Button.

2.Using the codes below, Make selection of the setup function you want to change by pressing and releasing the buttons labeled 1-9 until the appropriate LED’s are lit.

3.Increase the value of the parameter one step by each press of the Up Arrow button.

Decrease the value of the parameter one step by each press of the Down Arrow button

To read out the value of the code. Enter the Code on the handheld (See Steps 1 & 2). Press and hold the [Select Load] GPS button, and read the blinked code on the up and down arrows. Example: Steps, default is set at 45 degrees, so the down arrow will blink 8 times. When you are at the highest setting the up arrow will be solid. When you are at the lowest setting the down arrow will be solid.

Function	Code To Change		Parameters	Default
	Settings
Degrees Per Step	6	10	Choices/ 1,2,3,4,5,10, 15, 30, 45, or 90 Degrees	45 Degrees
Circle Time	7	10	Choices/ 1,2,3,4,5,10, 15, 30, 45, or 90 Minutes	5 Min
Zig- Zag Amplitude	8	10	Choices/ 5 to 50 degrees by 5’s	30 Degrees
Zig-Zag Period	9	20	Choices/ 1 to 20 minutes by 1’s	3 Min
Cloverleaf Length	29	500 ft to 1,000 ft by 50 ft increments		1,000 Ft
Search Spacing	249	50 ft to 1,000 ft by 50 ft increments		50 Ft
Orbits	The Autopilot will orbit the waypoint you have activated in your GPS at the distance from
	which you activate and enter the mode on the handheld.