X100 module switches
Certain aspects of operation can be affected by the switches on the X100 module.
OFF: Normal operation
ON: Flash upgrade
ON
1 | 2 |
|
|
| 3 | 4 | |
|
| ||
|
|
|
Determines configuration of hotkeys in conjunction with switch 3
Reserved for future use
Switch 1
OFF: Normal operation.
ON: (Before power is applied) Places the X100 module into flash upgrade mode so that the internal software can be changed. Please see the Flash upgrade section in the ‘Special configuration’ chapter.
Switches 2 and 3
contents
Determines configuration of hotkeys in conjunction with switch 2
ON 1 | 2 |
|
|
| 3 | 4 | |
|
| ||
|
|
|
Note: When shipped, all switches are set in the OFF positions and this will produce normal operation.
Switches 2 and 3 determine which two keyboard keys (when pressed in unison) are to be designated as ‘hotkeys’. Hotkeys signal to the X100 module that the next key to be pressed is a special configuration command for the module and is not to be passed to the computer system.
2 | OFF |
|
3 | OFF | Hotkeys = CTRL and SHIFT |
2 | OFF |
|
3 | ON | Hotkeys = ALT and SHIFT |
2 ON |
| |
3 | OFF | Hotkeys = CTRL and ALT |
2 ON |
| |
3 | ON | Hotkeys disabled |
Switch 4
This switch is reserved for future use.
special installation configuration & welcome