TRANSPORTING
On tractor pulled MODELS, always disconnect the PTO drive shaft from the tractor and return it to the PTO stor- age bracket on the box front before transporting. Failure to do this may result in equipment damage.
WARNING: INSTALL A SMV EMBLEM ON REAR OF FORAGE BOX FOR TRANSPORTING ON ROADWAYS. KEEP THIS EMBLEM CLEAN AND BRIGHT. FAILURE TO HEED MAY RESULT IN SERI- OUS PERSONAL INJURY OR DEATH.
Be sure and observe that the rear discharge door is latched closed before traveling on roadways.
If you will travel on public roads and it is legal to do so, you must know all rules governing such operation. This will include lighting and brake requirements in addition to traffic rules. You may also be required to install a safety chain device on the running gear.
TRACTOR TOWING SIZE REQUIREMENTS
Use the following chart for calculating the minimum trac- tor weight.
MODEL | FORAGE BOX EMPTY | MINIMUM | |
| WEIGHT + LOAD = GW | TRACTOR | |
|
|
| WEIGHT UP |
|
|
| TO 20 MPH |
8118 | 5,200 + _____ = _____ | 2/3 of box | |
|
|
| gross weight |
8120 | 5,400 + _____ = _____ | 2/3 of box | |
|
|
| gross weight |
8122 | 5,700 + _____ = _____ | 2/3 of box | |
|
|
| gross weight |
8124 | 6,200 + _____ = _____ | 2/3 of box | |
|
|
| gross weight |
|
|
|
|
MATERIAL ESTIMATED WEIGHT PER CUBIC FOOT | |||
|
| ||
MATERIAL | LBS / CU. FT. | ||
SOYBEANS | 47 LBS. |
| |
COTTON SEED DRY | 20 LBS. |
| |
CORN (SHELLED) | 45 LBS. |
| |
CORN SILAGE | 30 LBS. |
| |
HAYLAGE |
| 20 LBS. |
|
SAWDUST | 17 LBS. |
| |
|
|
|
|
SOURCE: ASAE
NOTE: HEAPED LOADS HAVE SIGNIFICANTLY HIGHER CAPACITIES
WARNING: MAKE CERTAIN EVERYONE IS CLEAR OF EQUIPMENT BEFORE APPLYING POWER. FAILURE TO HEED MAY RESULT IN SERI- OUS PERSONAL INJURY OR DEATH.
Your running gear for tractor pulled model probably has a telescoping tongue for convenience to hitch up. Always back up and lock this tongue in the operating position af- ter hitching.
WARNING: YOU MUST OBSERVE ALL AP- PLICABLE TRAFFIC LAWS WHEN TRANSPORTING ON PUBLIC ROADWAYS. CHECK LOCAL LAWS FOR ALL HIGHWAY LIGHTING AND MARKING RE-
8100 Rear Unload |