Installation | Triax SR-26 specification

To skip a program, “PR. SKIP” line is used. If it is enabled, the user can not reach this program with “P+”, “P-” buttons. Only direct accessing is enabled to watch the skipped program.

“TV” is used to return without saving, “Store” button to return to the program mode with saving for selected channel number.

To store the customizing page, ”Store” button is pressed and then program number begins to flash. “+”,”-” or “0-9” buttons are used to change channel number. After entering the program number ”Store” button is pressed again to save the program settings to this program.

Installation:

This page depends upon the DiSEqC mode selection in the setup menu. Setup menu and the other modes of this page will be explained later in “notes to the system in- staller” part.

While DiSEqC is OFF installation menu seems like this:

In this page, technical specifications for 8 different LNBs are defined. In the “LNB FREQ.” line, for each LNB, Local Oscillator frequency can be selected by using “+”, “-” buttons from 8 preset values: 9750, 10000, 10600, 10750, 11000, 11250, 11475 MHz for Ku Band and 5150MHz for C Band.

•In “POL” line, polarity is changed as vertical or horizontal by “+”,”-”.

•“22 kHz” can be switched for each LNB. 22 kHz can be used either for dish switch- ing (with a 22kHz switch) or Universal LNB frequency band switching. If DiSEqC is ON in setup menu, 22kHz can only be used for frequency band switching for universal LNB’s.

•“TONEBURST” signal can be used for each LNB to select dishes with a toneburst switch.

- 11 -