Kathrein MSK 200/S2 user manual Operation, Initial START-UP, Setting UP the Device, SET-UP Options

Page 7

OPERATION

INITIAL START-UP

Prior to operating for the first time, please take the T 8.0 A fuse out of the packaging and fit it into the provided fuse holder.

After insertion of the protector, the device muss be operated or charged on the power supply unit for ap- proximately two hours. Subsequently, the device must be completely discharged during battery-powered operation (until the device switches off by itself). Battery charge level can only be correctly displayed if the device has been fully charged and then fully discharged.

The fuse prevents the device being switched on unintentionally during transport.

Caution!

Please remove this fuse again before shipping the device!

Remove the AC power supply unit (100V ... 250V) supplied from the packaging and connect the device to the mains using the power supply. The Li ion rechargeable battery in the device will now be charged. The green light emitting diode indicates use of an external power source. You can check the charge state of the rechargeable battery by pressing the “Test“ key.

Caution!

See also “Charging indicator” and “DC supply socket” in the section “Interfaces”

SETTING UP THE DEVICE

When setting up the device pay attention to adequate ventilation!

To avoid a build-up of heat, the openings for the fan and the ventilation holes must always be kept clear. Set up the device as shown in the figure.

SET-UP OPTIONS

7

Page 6 Page 8
Image 7
Page 6 Page 8
Contents MSK 200/S2 PREFACE/IMPORTANT Notes General Safety InformationValidity of this Manual Content Symbols used on Kathrein devices and in manuals SafetySafety MSK 200/S2, Order no 50 Ω FEATURES/DELIVERY ScopeDelivery Scope MSK 200/S2, Order no 75 ΩSET-UP Options Setting UP the DeviceOperation Initial START-UPFor right-handed users For left-handed users Using the Device on the Shoulder StrapKeyboard Operation Setup Help LangGeneral Operation Help FunctionSources Touchscreen OperationSource Analyze General Operation General Operation Choice of the Signal Source Choice of the Signal Source and MeasurementSelecting the Desired Measurement Choosing the Channel to be MeasuredScope Marker or SettingSpectrum ConstOperation Remote ControlSignalling Function OverviewSaving Measured Values Reception RangesDemodulation Measurement OptionsDesign Technical AppendixFunctions Type MSK 200/S2 Digital Catv receiver J83 A, B, C Connections Service Service Main Services936.3448/A/0209/ZWT Technical data subject to change
Related manuals
Manual 24 pages 57.28 Kb
Top Page Image Contents