Important notes for siting and installation
Place of installation
Every electronic device generates heat. The rise in temperature, however, lies within a safe range. Slight colour changes may occur to sensitive furniture surfaces and veneers over the course of time due to the constant effect of heat. In conjunction with treated furniture surfaces, the unit’s rubber feet can likewise give rise to changes in colour. Where necessary, place the unit on a suitable pad.
Ventilation
The heat which is generated in this unit is dissipated quite adequately. Never install the receiver in a cabinet, shelf or rack with inadequate ventilation. Never close off the cooling slots on the unit.
Do not place objects on top of the unit. Maintain a clearance of at least 10 cm above the unit, so that the heat generated within the unit is conducted away without obstruction.
Humidity, exposure to sunlight, heat
Protect the unit against humidity, drips and splashing.
Do not place the unit close to radiators nor expose it to direct sunlight.
Mains voltage
Operate the receiver only from a 230V / 50 Hz mains voltage.
The unit must not be connected to the mains and switched on until after the connections have been set up for the antenna and TV set.
Grounding
The parabolic antenna is to be grounded in accordance with regulations. The relevant local and/or German VDE regulations are to be observed.
Remote control
Place the supplied batteries into the remote control. Ensure correct polarity of the batteries according to the + and – markings inside the battery compartment!
2. Connections
The following connections are located on the rear panel of the unit:
230V / 50 Hz AUDIO TV L a. R TV
Connect the mains cable with the mains socket.
Audio output, left and right channel for connection to a stereo system.
Connect the TV socket to your television set with the Scart cable, which is included in the scope of delivery.
VCR | VCR Scart socket for connection of a video recorder. | |||
SAT IF INPUT | Sat IF signal input and output for LNB supply and control signals – | |||
| Connect the cable from your satellite system to this socket. | |||
SAT IF OUTPUT | IF signal output | |||
DATA INTERFACE | RS 232 interface for serial data transmission for servicing. | |||
| ||||
| Receiver: | PC: |
| |
| Pin 2 | = RXD | Pin 2 | = RXD |
| Pin 3 | = TXD | Pin 3 | = TXD |
| Pin 5 | = GND | Pin 5 | = GND |
- 4 -