Andrew OM24SNG-RC manual Elevation Brake Replacement

Page 21

Elevation Brake Replacement

Caution

Step 1

Step 2

The elevation brake replacement procedure is identical to the azimuth brake replacement. Refer to the previous azimuth procedure for details.

This Procedure Should Only Be Performed In Non-Windy Conditions (Winds Under 15 mph). When the Brake Is Removed the Antenna Will Be Allowed to "Freewheel". Two Persons Are Required To Safely Remove and Reinstall the Brake Assembly. One Person To Perform the Replacement and the Other To Hold the Antenna In Position.

Locate the elevation brake at the front of the azimuth panning frame. Refer to Figure 8.

Elevation

Brake

Figure 8

Due to the weight of the boom the elevation boom and reflector must be sup- ported during the elevation brake replacement process. The antenna elevation axis should be driven to an angle high enough to provide clearance to work under the boom on the brake assembly. A 2 X 4 inch piece of lumber (or equiv- alent) should be used to support the boom and reflector as detailed in Figure

9.The elevation axis should be driven down until the boom and reflector are resting on the 2 X 4.

Reflector

Boom

2 X 4

Lumber

Figure 9

21

Component Replacement

Image 21
Contents Meter SNG Table of Contents Purpose Proprietary Data Information and Assistance IntroductionHour Technical Assistance Customer Service CenterCall From Call To Telephone Fax Call From Telephone FaxDo Not Service Or Adjust Alone Safety SummaryESD Precaution Keep Away From Live CircuitsAntenna DescriptionGeneral Introduction Antenna Drive System Cable Inspection MaintenanceCable Replacement Azimuth Rotational Limits Overhead View of Antenna Azimuth Access Port Positioned Over Cable Adjusting Nuts Azimuth Drive Cable Tension Adjustment StepAdjusting Azimuth Cable Tension Step Elevation Cable Tension Adjustment Elevation Drive Cable Tension Adjustment StepControls and Power Failure Azimuth Drive Step Emergency ProceduresBrake Release Screws Elevation Drive Step Component Replacement Brake WiresBrake Release Hardware Body Nuts Cover Brake Brake Release Weep Hole Protective Tube Brake Cover Elevation Brake Replacement Specifications 22SpecificationsAntenna Electrical Antenna Mechanical 23Specifications24Specifications Antenna DimensionsView 25SpecificationsAntenna Clearance Envelope Top View Antenna Clearance Envelope and Center of Gravity Side View