Andrew OM24SNG-RC manual Adjusting Azimuth Cable Tension

Step 5

Step 6

Step 7

Step 8

Step 9

Insert the precision key stock into the vertical slot in the azimuth spring housing, see Figure 2 (the key stock acts as a thickness (feeler) gauge) then starting with the lowest cable tension adjusting nut, (nearest the bottom of the antenna mount) tighten each cable until the key stock is just snug but can be slid up and down.

KeystockStock iInsertion

Figure 2. Detail View of Access Port

Showing Location of Precision Key Stock Insertion Point

Loosen the adjusting nut just slightly so that the key stock will move freely up and down and allow setting clearance on subsequently adjusted cables (Figure 3).

Figure 3. Adjusting Azimuth Cable Tension

Repeat step #5 for the next cable adjusting nut(s).

Return antenna to azimuth stowing position while maintaining current antenna elevation.

From the stow position, begin counter-clockwise rotation approximately 150°. The access port on the panning frame should now be positioned over the opposite end of the unadjusted cable assemblies. Repeat steps 5 and 6 for the cable tension adjusting nuts now accessible.

11 Maintenance