Maxplus Industries HTS 2100S+ manual Channel Selection

6.1 Getting Started

Manual Scan <Figure 6-7>

Select a transponder.

To change a transponder’s information (Frequency, Symbol Rate), use the NUMERIC buttons.

To add a new transponder, press the GREEN button.

To delete a transponder, press the YELLOW button with the cursor next to the Frequency parameter.

To search a transponder, set its different parameters and press .

Package Identifier (PID) Scan <Figure 6-8>

Select a transponder.

To change a transponder’s information (Frequency, Symbol Rate), use the NUMERIC buttons.

To add a new transponder, press the GREEN button.

To delete a transponder, press the YELLOW button with the cursor next to the Frequency parameter.

To search a transponder, set its different parameters and press CH/ CH. You can search a specific channel of the transponder by setting its PID data (Video, Audio and PCR).

<Figure 6-7> <Figure 6-8>

Note : If you cannot access programs after correctly completing a scan procedure, please contact your seller or your installer.

6.1 Getting Started

4) Channel Selection

You can use CH/ CHto navigate between channels until you find the channel you want.

If you know the channel number, you can enter it with the NUMERIC buttons and wait 2 seconds until the channel is changed.

If you know the channel name or transponder or CAS, you can press to display the channel list <Figure 6-9>

<Figure 6-9>

In the left side of screen, detailed information about the selected channel will be displayed. (Satellite Name, Frequency(Polar) and Channel Name)

You can use the following buttons to navigate between channels: - CH/ CH: Moves one channel up/ down.

- VOL / VOL: Moves one page up / one page down.

-RED : Shows all channels in the current group.

-GREEN : Shows all channels sorted alphabetically.

-YELLOW : Shows all channels sorted by Transponder.

-BLUE : Shows all channels sorted by CAS system.

Press when the selection bar is positioned on the desired channel.

16 17