English
SYSTEM AND COMPONENT SPECIFICATIONS
RF Carrier Frequency Range
169.445 to 240.000 MHz
Operating Range:100 m (328 ft.) under typical conditions Audio Frequency Response: 50 to 15,000 Hz, 3 dB Image Rejection: 75 dB typical
Spurious Rejection: 75 dB typical
System Distortion (ref. 15 kHz deviation, 1 kHz modula- tion): 0.1% THD typical
Signal/Noise Ratio: 102 dB
Sensitivity: ±110 dBm for 12 dB SINAD typical
Operating Temperature Range
±18° to 57° C (0° to 135° F) NOTE: Battery characteristics may limit this range.
Battery Life: 18 hours with 9 V alkaline battery (Duracell MN1604 recommended).
AXB1, AXB1G BODYPACK
TRANSMITTER SPECIFICATIONS
RF Output | 50 mW Typical | |
|
| |
Input | Unbalanced | |
Configuration | ||
1/4 Inch (AXB1G); | ||
Connector Type | ||
Actual Impedance | 1 MΩ | |
|
| |
Maximum | +12 dBV | |
Recommended | ||
Input Level* |
| |
|
| |
Minimum | ±80 dBV | |
Recommended | ||
Input Level** |
| |
|
| |
Connector Pin | Pin 1:Tied to Ground | |
Pin 2:Tied to +5 V | ||
Assignments | ||
Pin 3:Tied to Audio | ||
(AXB1) | ||
Pin 4:Tied to 20kΩ Resistor and Audio Ground | ||
| ||
|
| |
Connector Pin | Sleeve: Tied to Ground | |
Assignments | ||
Tip: Tied to Audio | ||
(AXB1G) | ||
| ||
|
| |
Dimensions | 64 mm H x 106 mm W x 24 mm D | |
| (2.52º H x 4.17º W x 0.95º D) | |
|
| |
Net Weight | 96.4g (3.4 oz.) | |
Power | 9 V alkaline battery (Duracell MN1604 | |
Requirements | recommended); 8.4 V NiCd battery optional. | |
|
| |
Nominal Current | 30 mA | |
Drain | ||
|
*Gain Control at minimum
**Gain Control at maximum
AXR3 AND AXR4N RECEIVER SPECIFICATIONS
| AXR4N | AXR3 |
|
|
|
Connector | 1/4º Phone Jack | |
| 1/4º Phone Plug |
|
|
|
|
Maximum Output | 1/4º: + 5dBV | ±6.8 dBV |
Levels at 15 KHz | XLR: ±10 dBV |
|
deviation |
|
|
|
|
|
Nominal Output | 1/4º: ±8 dBV | ±32 dBV |
Levels | XLR: ±30 dBV |
|
|
|
|
Output Configuration | Active Balanced | Unbalanced |
|
|
|
Actual Impedance | 3.3 KΩ | 1 KΩ |
|
|
|
Connector Pin | XLR: Pin 1: ground; | Tip: hot; Sleeve: |
Assignments | Pin 2: hot; Pin 3: cold | ground |
| 1/4º: Tip: hot; Sleeve: |
|
| ground. |
|
|
|
|
Dimensions (AXR4N) | 41 mm H x 197 mm W x 138 mm D | |
| (1.625º H x 7.77º W x 5.42º D) | |
|
| |
Dimensions (AXR3) | 35mm H x 152 mm W x 98 mm D | |
| (1.38ºH x 5.98º W x 3.85º D) | |
|
|
|
Net Weight (AXR4N) | 435 g (15.4 oz.) |
|
|
|
|
Net Weight (AXR3) | 192 g (6.8 oz.) |
|
|
| |
Power Requirements | 12±18 VDC nominal, 200mA | |
|
| |
Power Supply | 120 V or 230V AC adaptor with 2.1 mm female | |
| plug |
|
|
|
|
Voltage/Current/Phant | Yes | Yes |
om Power Protection |
|
|
Certification
AXB1G, AXB1:Accepted under FCC Parts 74 and 90. Certi- fied by IC in Canada under
AXH2/31, AXH2/58: Type Accepted under FCC Parts 74 and 90. Certified by IC in Canada under
AXR3, AXR4N: Approved under the Declaration of Conformity provision of FCC Part 15 (AXR3). Certified by IC in Canada under RSS 123 (AXR4N). Conforms to European Union di- rectives, eligible to bear CE marking; mets European Union Requirements. EMC Immunity: pr ETS 300 445. Power sup- ply meets Low Voltage Directive: 73/23/EEC.
AXH2 HAND-HELD TRANSMITTER SPECIFICA- TIONS
| AXH2/58 (SM58) |
| AXH2/31(BG3.1) |
|
|
| |
RF Output | 50 mW Typical (FCC); 20 mW Typical (ETSI) | ||
|
|
|
|
Dimensions | 236 mm H x 51 mm D |
| 222 mm H x 51 mm D |
| (9.29º H x 2.01º D) |
| (8.74º H x 2.01º D) |
|
|
|
|
Net Weight | 295g (10.4 oz.) |
| 266g (9.4 oz.) |
|
|
| |
Power Requirement | 9 V alkaline battery (Duracell MN1604 recom- | ||
| mended); 8.4 V NiCd | battery optional. | |
|
|
|
|
Nominal Current | 30 mA |
| 30 mA |
Drain |
|
|
|
7