Simple Configuration (Single LNB, No Multiswitch)
A simple configuration without a multiswitch might look like the following illustra- tion. The SIRIUS signal and the satellite TV signal are combined into one and use the existing satellite TV cable run from the roof all the way into the room in- side the home where the SIRIUS radio and satellite TV receiver are located. The signals are then split and connected to each device. The benefit of the SIRIUS Combiner/Splitter in this scenario is avoiding having to run an additional cable for the SIRIUS radio from the roof all the way into a room in the interior of the home.
SaTellITe | SaTellITe DISH |
oUTDooR anTenna |
SaTellITe RaDIo
Adapter
Cable
C
ComBIneR
Common 
CaBle RUn
TV
S
SPlITTeR
The next diagram shows the same configuration. Note that in the common cable run between the Combiner and Splitter there are no devices such a splitter or DishPro Adapter. If a DishPro adapter is needed, it must be installed after the Splitter as shown.
Home Signal Distribution Kit Installation Guide |