Sirius Satellite Radio 128-8665, SSDK1, SR-101C, SR-2251 manual CombinerSplitter

4.Disconnect the cable from the satellite dish LNB and connect it to the

COMBINED OUT port on the Combiner (SR2261) as shown. (Refer to page 5 for the Combiner port identification.)

5.Using another of the RG-6 cables which you purchased, connect it between the satellite dish LNB and the DBS IN port on the Combiner (SR2261) as shown. (Refer to page 3 for the Combiner port identification.)

Step 6 Step 8 Step 9

CombinerSplitter

C S

Step 10 Step 7

6.Disconnect the existing cable run from the satellite TV receiver/tuner in the room where the SIRIUS radio will be located. Connect this end of the cable to the COMBINED IN port on the Splitter (SR2251) as shown. (Refer to page 5 for the Splitter port identification.)

7.Connect another of the RG-6 cables you purchased between your satellite TV receiver/tuner and the DBS TV port on the Splitter (SR2251) as shown. (Refer to page 5 for the Splitter port identification.)

8.Connect another of RG-6 cables you purchased between the SIRIUS OUT port on the Splitter (SR2251) and the F connector end of the supplied RG- 174 Adapter cable as shown. (Refer to page 5 for the Splitter port identifica- tion.)

9.Connect the other end of the RG-174 Adapter Cable to the ANT connection on your SIRIUS radio as shown.

10.Verify that the satellite TV receiver/tuner is plugged into a working AC out- let. Next, connect the provided AC Power Adapter to the POWER IN port of the Splitter (SR2251), and plug it into a working AC outlet.

The installation is now complete.

Home Signal Distribution Kit Installation Guide 29