Simple Configuration Installation Procedure (Single LNB, No Multiswitch)
Once the antenna has been mounted according to the previous instructions, you can continue with the installation of the Combiner and Splitter:
1.Be sure that the satellite TV receiver/tuner is plugged into an AC outlet.
2.Take the RG-6 cable which you purchased to connect to the SIRIUS anten- na and thread one end of the cable through the opening in the end of the rubber boot. Then connect the cable to the antenna pod as shown in the illustration following. Slide the rubber boot over the cable connection to pro- vide a weather proof seal and install the cable tie around the cable directly below the rubber boot to prevent the rubber boot from slipping down. Trim off the excess cable tie. Route the remainder of the antenna cable to where you are locating the Combiner. When routing the antenna cable, be careful not to pinch, squash, kink, or crimp the cable, or cut, damage, or puncture the external jacket of the antenna cable.
3.Connect one of the RG-6 cables you purchased from the SIRIUS antenna to the SIRIUS RADIO port on the Combiner (SR2261) as shown. (Refer to page 5 for the Combiner port identification.)
Step 2
Step 5
Step 3
Step 4
Combiner
EXISTING RG-6 CABLE
C 
28 | Home Signal Distribution Kit Installation Guide |