Sirius Satellite Radio SR-101C manual Existing RG-6 Cable

4.Disconnect the cable from the multiswitch and connect it to the COMBINED OUT port on the Combiner (SR2261) as shown. (Refer to page 5 for the

Combiner port identification.)

5.Using one of the RG-6 cables which you purchased, connect it between the multiswitch and the DBS IN port on the Combiner (SR2261) as shown. (Re- fer to page 5 for the Combiner port identification.)

Multiswitch

M

EXISTING

RG-6 CABLE

Step 6 Step 8 Step 9

CombinerSplitter

C S

Step 10 Step 7

6.Disconnect the existing cable run from the satellite TV receiver/tuner and connect this end of the cable to the COMBINED IN port on the Splitter (SR2251) as shown. (Refer to page 5 for the Splitter port identification.)

7.Connect another of the RG-6 cables you purchased between the satellite TV receiver/tuner and the DBS TV port on the Splitter (SR2251) as shown. (Refer to page 5 for the Splitter port identification.)

8.Connect another of RG-6 cables you purchased between the SIRIUS OUT port on the Splitter (SR2251) and the F connector end of the supplied RG- 174 Adapter cable as shown. (Refer to page 5 for the Splitter port identifica- tion.)

9.Connect the other end of the RG-174 Adapter Cable to the ANT connection on your SIRIUS radio as shown.

10.Verify that the satellite TV receiver/tuner is plugged into a working AC out- let. Next, connect the provided AC Power Adapter to the POWER IN port of the Splitter (SR2251), and plug it into a working AC outlet.

The installation is now complete.

Home Signal Distribution Kit Installation Guide 35