Wegener Communications DTV742 quick start Web Browser User Interface

Page 5

Main-level Screens

Second-level Screens

IP Setup

IP Address Selection

IP Setup ...

IP Address:

 

0 . 0 . 0 . 0

Press the ENT key to go to IP Address Selection.

Press the ENT key and then press the arrow keys to change the IP

Press the 4 key to go to Reset Unit.

address. Press the ENT key to confirm the selection or ESC to

cancel changes.

Press the 3 key to go to Panel Help Timeout.

Press the 4 key to go to the Netmask Selection.

Press the ESC key to go to the Home Screen.

Press the ESC key to go to IP Setup.

 

 

Netmask Selection

 

Netmask:

 

255 . 255 . 0 . 0

 

Press the ENT key and then press the arrow keys to change the

 

Netmask. Press the ENT key to confirm the selection or ESC to

 

cancel changes.

 

Press the 4 key to go to Gateway Selection.

 

Press the 3 key to go to IP Address Selection.

 

Press the ESC key to go to IP Setup.

 

Gateway Selection

 

Gateway:

 

0 . 0 . 0 . 0

 

Press the ENT key and then press the arrow keys to change the

 

Gateway. Press the ENT key to confirm the selection or ESC to

 

cancel changes.

 

Press the 3 key to go to Netmask Selection.

 

Press the ESC key to go to IP Setup.

Unit Reset

 

Reset Unit ...

 

Press the ENT key to reset the unit and start the bootloader.

 

Press the 3 key to go to IP Setup.

 

Press the ESC key or 4 to go to the Home Screen.

 

Web Browser User Interface

In addition to the front panel, the user may control and monitor the unit using the rear-panel Ethernet connection. Before using the Ethernet connection, the appropriate IP address, netmask, and gateway must be selected via the front-panel interface. There are two basic methods of using the Ethernet connection – with a directly connected PC or with a LAN connection.

Locally connected PC –

Connect the DTV744 Ethernet connection to the Ethernet network connector on the PC using a crossover RJ-45 cable (8 pins).

Set the DTV744 IP Setup as follows: IP Address: 172.016.100.020

Netmask: 255.255.000.000

Gateway: 000.000.000.000

 

 

Set the PC IP address as follows:1

IP Address: 172.016.100.001

Subnet Mask: 255.255.000.000

Connect to the DTV742 using the web browser instructions below.

LAN Connection –

Connect the DTV742 Ethernet connection to the LAN using a normal RJ-45 cable (8 pins). Set the DTV744 IP Address, Netmask, and Gateway as directed by your network administrator. Use any PC on the LAN to connect to the DTV744 using the web browser instructions below.

1To change the PC IP address, go to the Settings, Control Panel and double click on the Network icon. Select Configuration, TCP/IP protocol, and click on the Properties box. Click on Specify IP Address and set the IP Address and Subnet Mask as indicated. Click OK to restart the PC with the new values.

800057-02 Rev. A

Page 5 of 11

May 24, 2003

Image 5
Contents Front and Rear Panel View Connector/Pin-out Information DTV742 Installation Quick Start GuideBasic System Setup Diagram Front-panel User Interface 3rd-level RF Standard 3rd-level Tuner Enable3rd-level Channel Number Selection 3rd-level Program Status Front-panel Help TimeoutWeb Browser User Interface Using the Web Browser 800057-02 Rev. a 800057-02 Rev. a 800057-02 Rev. a 800057-02 Rev. a Environmental Operating Conditions & Physical Specifications