Wegener Communications DTV742 quick start Basic System Setup Diagram Front-panel User Interface

Basic System Setup Diagram

Front-panel User Interface

Note that from any screen, pressing the ESC key twice will return you to the Home Screen.

Main-level Screens		Second-level Screens
Home Screen (rotates through data from each of the four RF		Serial Number and Application Software Version Number
inputs)	8VSB	Screen
RF3 CHAN:20		S/N:XXXXXX
SNR21 . 5 ErrSec:0002		VER:YYY
The channel number, modulation type (8VSB, 64QAM, or		Where XXXXXX is the unit's six-digit serial number and YYY is
256QAM), signal-to-noise ratio, and errored seconds are		the version number of the unit's currently installed application
displayed for each input.		software.
Press the 4 key (if displayed) to go to Alarms/Warnings.		Press the ESC key to go to the Home Screen.
Press the ENT key to view the second-level Serial Number
and Application Software Version Number screen.
Alarms/Warnings		2nd-level Alarms/Warnings Message Screen
View Alarms/Warnings		No Alarms or Warnings
Press the ENT key to view any active alarms or warnings on		Any active alarms or warnings are described here.
the second-level Alarms/Warnings Message screen.
		Press the 4 key to view the next alarm or warning (if more than
Press the 4 key to go to Clear Errored Seconds (if counter is
		one).
non-zero) or Program Setup.
		Press the ESC key to return to the Alarms/Warnings screen.
Press the ESC key to go to the Home Screen.
Clear Errored Seconds
Clear Errored	Secs
Press<ENT>
This screen only appears if the errored seconds counter is
non-zero. Otherwise the next screen, Program Setup is
displayed.
Press the ENT to clear the errored seconds counter.
Press the 4 key to go to the Input Setup screen.
Press the 3 key to go to Alarms/Warnings.
Press the ESC key to go to the Home Screen.

800057-02 Rev. A Page 2 of 11 May 24, 2003