Insignia NS-TVMFP12 specifications Option 1 Installing on a wood stud wall

FIXED-POSITION WALL MOUNT FOR TVs 19-39 in.

STEP 5 - Option 1: Installing on a wood stud wall*

Note: Any drywall covering the wall must not exceed 5/8 in. (16 mm).

1Locate the stud. Verify the center of the stud with an edge-to-edge stud finder.

2Align the wall plate template (P) at the height you determined in the previous step (or by using the HeightFinder mentioned on the template), make sure that it is level, then tape it to the wall.

3Drill pilot holes through the template to a depth of 3 in. (75 mm) using a 7/32 in. (5.5 mm) diameter drill bit, then remove the template.

4Align the wall plate (A) with the pilot holes, insert the lag bolts (S) through the lag bolt washers (R), then through the holes in the wall plate. Tighten the lag bolts only until they are firm against the wall plate.

CAUTION: Avoid potential injuries or property damage!

DO NOT over-tighten the lag bolts (S).

* Minimum wood stud size: common 2 x 4 in. (51 x 102 mm) nominal 11/2 x 31/2 in. (38 x 89 mm).

A

3 in.

(75 mm)

SR

You’ll need

		7/32 in. wood	1/2 in. socket wrench
Wall plate (A)	Edge-to edge	drill bit
	stud finder	Drill
Wall plate template (P)	S (2)	Level	Tape
	R (2)

10www.insigniaproducts.com