Technicolor - Thomson 42 WM 03 L Programming your remote control, Programming Volume Mute Keys

Miscellaneous

Programming your remote control

To control other devices

You can program your remote control for it to control other devices. Before following the adjustment procedure below, look for the 3- digit code number(s) corresponding to the make of the device(s) to be controlled in the list of codes enclosed separately, then insert them in the table below.

1. Position the switch on the device that you want to control.

Apparatus	Codes
VCR
Satellite receiver
DVD or LD unit
Amplifier

2. Keep the key down and enter the 3-digit code.

3. Release the menu key.
• Try to control the device by turning it off, then on with the	key
(the above key being on the corresponding position).

•If this does not work, repeat the process from step 2 with another 3-digit code.

•Some devices cannot be controlled by the universal remote control supplied.

•Test the functions that you can control by using this remote control.

•According to the devices and the date they were put on the market, all the functions may not be available.

•If you have programmed you remote control to control other makes than Thomson, it may be necessary to reprogram it when you change the batteries.

Programming Volume and Mute keys

Your remote control has been factory-set to control the Volume +/- and Mute ( ) functions on the THOMSON DPL 2000 amplifier.

If you wish to control the Volume +/- and Mute ( ) functions on your set, you

must change the factory-settings as follows:

1. Slide the key to the plasma position.

2. While maintaining the	key pressed, key in the code "001".	Amplifier	Monitor
		Code	Code
3. Release the menu button.		000	001

Volume +/- and Mute ( ) keys are now configured to control the set. To control the amplifier, place the key on the hi-fiposition. To return to factory-settings, repeat the above procedure, keying in "000".

30 Plasma Monitor