Installation Instructions |
ADJUSTMENTS
Pivot/Height Tension
WARNING: Excessive loosening or tightening of adjustment mechanism can result in serious personal injury
Pitch Adjustment
1.Pull entire handle out away from mount to allow handle position to be adjusted to be prior to pitch adjustment. (See Figure 13)
NOTE: In order to maximize leverage, position handle in lower position.
or damage to equipment!
1.To adjust extension/swivel, slightly loosen or tighten adjustment screws using hex key (R) (See Figure 12). Adjust screws ONLY as required to achieve desired tension.
2.Adjust handle to desired position. (See Figure 13)
3.Push entire handle back towards mount prior to pitch adjustment. (See Figure 13)
2.To adjust height tension, slightly loosen or tighten adjustment screw as necessary using hex key (Q) (See Figure 12).
•If display settles on its own, then rotate adjustment screw counterclockwise (towards the “+” symbol).
•If display rises on its own, then rotate adjustment screw clockwise (towards the
NOTE: It may be necessary to raise or lower the height adjustable arm to expose the adjustment screw.
1(R)
DARKWE110 
(Other models similar)
2 | (Q) |
Figure 12
| 1 |
3 | 2 |
Figure 13
IMPORTANT ! : Make sure the weight of the display is adequately supported while adjusting the pitch in Steps
4.Lift handle up until pitch can be adjusted easily. (See Figure 14)
5.Adjust pitch to desired position. (See Figure 14)
6.Push handle down until faceplate is locked at desired pitch position. (See Figure 14)
5 |
4 |
6 |
Figure 14
11