Display Installation

MSP-DARKWE/CE/CD/PZ-110

Installation Instructions

To Desk (MSP-DARKCE110, MSP-DARKCD110)

1.Determine approximate location for mount keeping in mind display size, arm extension, and pitch/roll requirements.

2.Using mount (B) as a template, mark location of three pilot holes (See Figure 4).

3.Drill three 1/8” diameter pilot holes in mounting structure at marked locations (See Figure 4). Ensure pilot holes are straight.

4	(F) x 3
		(G) x 3
2	x3
3	x3	B
3	x3
1/8” (3.2mm)

Figure 4

IMPORTANT ! : IF you will be installing a display with RECESSED mounting holes, then proceed to “DISPLAY INSTALLATION” before continuing with this mount installation procedure.

4.Install three #10 x 1 1/2” Phillips head screws (F) through three #10 washers (G) and mount (B) into pilot holes (See Figure 4). Tighten screws.

5.Proceed to “CABLE MANAGEMENT” if your display was previously installed, or to “DISPLAY INSTALLATION” if your display is not installed.

To Pole (MSP-DARKPZ110)

IMPORTANT ! : The following installation instructions assume that a 1-1/2” NPT pipe has been properly installed and is in place.

1.Determine approximate location for mount keeping in mind display size, extension, height adjustment (if applicable), and pitch/roll requirements.

IMPORTANT ! : IF you will be installing a display with RECESSED mounting holes, then proceed to “DISPLAY INSTALLATION” before continuing with this mount installation procedure.

2.Place mount (V) against pole, with clamp (U) on opposite side of pole (See Figure 5).

3.Using 5/32” hex key (Q), loosely assemble with three 1/4-20 x 1-1/4” button head cap screws (T). (See Figure 5)

3	(T) x 3
(V)
	(U)
	Pole

Figure 5

NOTE: Equally tighten screws (T) against clamp (U) and mount

(V). (See Figure 6)

(T) x 3

(U)

Keep equal distance between mount and clamp when

tightening

(V)

Figure 6

4.Position mount at desired height and orientation. Tighten screws (T) securely.

5.Proceed to “CABLE MANAGEMENT” if your display was previously installed, or to “DISPLAY INSTALLATION” if your display is not installed.

NOTE: In Figures 7 and 8 the swing arm has been removed for clarity.

WARNING: Exceeding the weight capacity can result in serious personal injury or damage to equipment! It is the installer’s responsibility to make sure the combined weight of all components attached to the MSP-DARKWE110/- DARKCE110 does not exceed 20 lbs (9 kg), MSP- DARKCD110/MSP-DARKPZ110 - 25 lbs (11.3 kg).

1.Carefully place display face down on protective surface.