PAC516 | Installation Instructions |
WARNING: ELECTRICAL SHOCK HAZARD! CUTTING OR DRILLING INTO ELECTRICAL WIRES OR CABLES CAN CAUSE DEATH OR SERIOUS PERSONAL INJURY! ALWAYS make certain area behind mounting surfaces is free of electrical wires and cables before cutting, drilling, or installing fasteners.
2.Secure accessory box to studs by:
WOOD STUD:
1.Drill four 3/16" dia. pilot holes in studs at mounting holes. (See Figure 3)
2.Install four M7 x 40mm Allen head connector screws
(F)into pilot holes using an M4 Allen head drill bit
(D).(See Figure 3)
STEEL STUD:
1.Drill four 3/16" dia. pilot holes in studs at mounting holes. (See Figure 3)
2.Install four 1/4" countersunk finishing washers (B) and four 1/4" x 2" Phillips flat head self drilling screws (G) into pilot holes. (See Figure 3)
| 1 | x 4 |
| 2 | (F) x 4 |
(B) x 4 |
|
|
(Steel Stud Only) |
|
|
2 | (G) x 4 |
|
(Steel Stud Only) | ||
Figure 3
DANGER: IMPROPER WIRING CAN LEAD TO DEATH OR SEVERE PERSONAL INJURY! Grounding must be installed by qualified personnel using a UL Recognized No. 12AWG Green and Yellow grounding wire connected to grounding lug on mount.
1 |
2 |
Typical |
Grounding lug location |
Figure 4
Installing Accessories
Accessories can be mounted directly to the PAC516 by using the mounting screws provided and the mounting holes integrated into the box.
To mount an accessory:
1.Identify area within accessory box where accessory is to be mounted.
2.Align the mounting holes in accessory with mounting holes in box.
3.Secure accessory to box using Phillips screwdriver and as many
4.Use the wire tie clips (C), as necessary, for cable management. (See Figure 5)
6