Installation, Attaching Mount to NPT Pipe

Installation Instructions

MCD Series

INSTALLATION

WARNING: FAILURE TO PROVIDE ADEQUATE STRUCTURAL STRENGTH FOR THIS COMPONENT CAN RESULT IN SERIOUS PERSONAL INJURY OR DAMAGE TO EQUIPMENT! It is the installer’s responsibility to make sure the structure to which this component is attached can support five times the combined weight of all equipment. Reinforce the structure as required before installing the component.

IMPORTANT ! : These installation instructions assume that a 1-1/2" NPT or NPSM following ANSI/ASME B1.20.1 (Schedule 40, 0.154" minimum thickness steel or aluminum - ASTM B221) threaded extension column (not included) has been properly installed and is in place.

Attaching Mount to NPT Pipe

CAUTION: Watch for pinch points. Do not place fingers between moveable parts.

1.Thread the MCD mount (A) onto the existing 1-1/2" NPT or NPSM pipe (not included) until tight, with a minimum of four threads engaged. (See Figure 1)

2.Install and tighten the 5/16-18 x 3/8" set screw (B). (See Figure 1)

NPT
Pipe
(A)
1	2	(B) x 1

Figure 1

Attaching Interface Bracket to Displays

1.Attach MSBU or MSBV interface bracket to displays following instructions included with MSBU/MSBV interface bracket kit.

Attaching Displays to Mount

1.While supporting both sides of display, align four mounting buttons on interface bracket with four mounting holes in mount. (See Figures 2, 3 and 4)

(A)

Display

Figure 2

WARNING: DISPLAY MAY WEIGH IN EXCESS OF 40 LBS! Always use two people and proper lifting techniques when installing or positioning display on mount.

2.Lower display into place listening for audible "click" to ensure recessed area of mounting buttons are properly seated in lower area of mounting holes and ClickConnect mechanism has engaged. (See Fig. 2, 3 and 4)

3.Repeat Steps 1 and 2 for second display.

	MSBV interface
	bracket
Back	(example only)
of Display
(A)

Figure 3