MCD Series | Installation Instructions |
WARNING: IMPROPER INSTALLATION CAN LEAD TO DISPLAY FALLING CAUSING SERIOUS PERSONAL INJURY OR DAMAGE TO EQUIPMENT! Ensure mounting buttons are completely engaged in mounting holes.
Holes are provided in the faceplate for use with a padlock or similar locking device, if desired. In addition, the pin and nut may be removed from the upper holes and moved to the lower holes for use as a more permanent locking device. (See Figure 4).
To use as a more permanent lock, remove 1 pin and nuts and move
to lower holes. 
2
A padlock or bolt may
be placed through latch holes
Figure 4
Removing Displays
1.Disconnect all power/audio/video cables.
2.Remove bolt or padlock from faceplate (if used). (See Figure 5)
NOTE: The pin may have been used as a more permanent locking device. If so, remove nut and pin and move from the lower holes to the upper holes.
3.Pull back on flag on upper mounting hole and press pin down into "Open" position. (See Figure 5)
WARNING: THE DISPLAY MAY WEIGH IN EXCESS OF 40 LBS EACH! Always use two people and proper lifting techniques when installing or positioning display.
4.Carefully lift display from mount.
5.Lift up on pin and place flag back against faceplate to return it to "Closed" position. (See Figure 5)
2 | Remove bolt |
|
or padlock |
| |
| if used | 3 |
Pin in |
|
|
"Closed" |
| |
position - |
| |
Move to |
| |
"Open" |
|
|
position to |
| |
remove |
| |
display |
|
|
| 5 |
|
Pin in |
|
|
"Open" |
| |
position - |
| |
Move to |
| |
"Closed" |
| |
position |
| |
after display |
| |
is removed |
| |
Figure 5
Adjusting Display
CAUTION: Watch for pinch points. Do not place fingers between movable parts.
6