Polk Audio DR-3 instruction manual Introduction, Polk Audio Limited Warranty

Page 2

Table of Contents

 

DR-3 Remote Guided Tour

3 - 5

Button Function Chart

6

Programming the Remote

 

Manual Three-Digit Code Method

7

Auto Search Method

8

Finding the Three-Digit Code Number for a Device

8

Teaching Method

9

Erasing a Learned Command From a Button

10

Erase All Learned Commands in One Source/Device

10

Erase All Learned Commands in All Device Modes

11

Restoring Factory Programming

11

Macro Operation

 

Programming the Macro Button

12

Erase a Macro Sequence

12

Macro Programming Example

13

Setup Codes Chart

14 - 15

INTRODUCTION

The Polk Audio DR-3 Unified Learning Remote was designed to operate the Polk Audio Digital Solution home theater system and Polk Audio DP-1 CD/DVD player. It can also be programmed to operate most DVD and CD players, TVs, Cable and DSS tuners as well as VCRs. By following the easy steps in this manual, you can reduce or eliminate the need for having several remote controls on your coffee table.

As nifty as it may be, the DR-3 unified remote cannot duplicate every function of every remote control without turning it into a nightmare of tiny buttons. For control of the rarely used functions of the Digital Solution preamp/processor and the other equipment in your system, you’ll have to use their dedicated remotes. If you can’t find them, look under the sofa cushions; they’re probably there.

All of the buttons except for the CODE, SAVE, CNCL, LEARN, LIGHT, MACRO, VOL UP, VOL DOWN, SURROUND MODE, MUTE, SYSTEM POWER, SUB+, SUB- and the eight MODE buttons have “learn” functions and can learn the commands of other remote control devices.

POLK AUDIO LIMITED WARRANTY

Polk Audio, Inc., warrants to the original purchaser only that the

DR-3 Remote Control (the “Product”) will be free from defects in material and workmanship for a period of three (1) year from the date of original retail purchase from a Polk Audio Authorized Dealer. However, this Warranty will automatically terminate prior to the expiration if you sell or otherwise transfer the Product to any other party. The original retail purchaser shall hereinafter be referred to as “you.” To allow Polk Audio to offer the best possible warranty service, please fill out the Product Registration Card(s) and send it to the Factory, at the address provided on the Product Cards(s) within ten (10) days of the date of purchase.

Defective Products must be shipped, together with proof of purchase, prepaid insured to the Polk Audio Authorized Dealer from whom you purchased the Product, or to the Factory at 2550 Britannia Boulevard, Suite D, San Diego, California 92154. Products must be shipped in the original shipping container or its equivalent; in any case the risk of loss or damage in transit is to be borne by you. If upon examination at the Factory or Polk Audio Authorized Dealer it is determined that the unit was defective in materials or workmanship at any time during this Warranty period, Polk Audio or the Polk Audio Authorized Dealer will, at its option, repair or replace with new or reconditioned parts this Product at no additional charge, except as set forth below. All replaced parts and Products become the property of Polk Audio. Products replaced or repaired under this warranty will be returned to you, within a reasonable time, freight prepaid.

This warranty does not include service or parts to repair damage caused by accident, disaster, misuse, abuse, negligence, inadequate packing or shipping procedures, commercial use, voltage inputs in excess of the rated maximum of the unit, cosmetic appearance of cabinetry not directly attributable to defect in

materials or workmanship, or service, repair, or modification of the Product which has not been authorized or approved by Polk Audio. This warranty shall terminate if the Serial

number on the Product has been removed, tampered with or defaced.

This warranty is in lieu of all other expressed Warranties. If this Product is defective in materials or workmanship as warranted above, your sole remedy shall be repair or replacement as provided above. In no event will Polk Audio, Inc. be liable to you for any incidental or consequential damages arising out of the use or inability to use the Product, even if Polk Audio, Inc. or a Polk Audio Authorized Dealer has been advised of the possibility of such damages, or for any claim by any other party. Some states do not allow the exclusion or limitation of consequential damages, so the above limitation and exclusion may not apply to you.

All implied warranties on this Product are limited to the duration of this expressed Warranty. Some states do not allow limitation on how long an implied Warranty lasts, so the above limitations may not apply to you. This Warranty gives you specific legal rights, and you also may have other rights which vary from state to state.

This Warranty applies only to Products purchased in the United States of America, its possessions, and U.S. and NATO armed forces exchanges and audio clubs. The Warranty terms and conditions applicable to Products purchased in other countries are available from the Polk Audio Authorized Distributors in such countries.

“Polk Audio,” and “The Speaker Specialists” are trademarks of Britannia Investment

Corporation used under license by Polk Audio Incorporated.

2

Polk customer service (800) 377-7655

Image 2
Contents DR-3 Polk Audio Limited Warranty IntroductionDR-3 Remote Guided Tour VOLStop Page DR-3 Function List Button NameProgramming the Remote Manual Three-Digit Code MethodAuto Search Method Finding the Three-Digit Code Number for a DeviceTeaching Method Erasing a Learned Command From a Button To Erase All the Learned Commands One Source/Device ModeErasing All the Learned Commands All Device Modes Restoring Factory ProgrammingTo Erase a Macro Sequence Macro OperationProgramming the Macro Button Factory Reset Macro Sequence Programming ExampleSetup Codes Manufacturer/Brand Set-Up Code NumberVCR Aiwa RM2070-1