Niles Audio RCA-TT manual Installation Considerations

Page 4

INSTALLATION CONSIDERATIONS

WARNING – TO PREVENT POSSIBLE INJURY, THE FOLLOWING BASIC SAFETY PRECAUTIONS SHOULD BE OBSERVED IN THE INSTALLATION AND USE OF YOUR RCA-TT REMOTE CONTROL ANYWHERE! KIT.

1.Read through the entire manual – Before attempting any installation, read this manual thoroughly and keep it for future reference.

2.Avoid contact with all high voltage electrical wiring and equipment.

3.Keep away from water and moisture – Never use or install electronic products near water, ie., near a bathtub, sink, washing machine, in a wet basement, near a swimming pool, or anywhere else the product may be exposed to water or moisture.

4.Power supply cord protection – Do not run the power cord where it may be subject to wear or abuse. Do not allow anything to rest on or roll over the power cord which may damage it.

6.Lightning – It is suggested that you remove the power supply from the wall if your system will not be used for long periods of time. Power surges due to lightning strikes may damage your equipment.

7.Check your local building and electrical codes – There may be specific requirements regarding running low voltage in your area.

2

Image 4
Contents RCA-TT Table of Contents CongratulationsContents IntroductionInstallation Considerations Tools Required InstallationGetting Started Connection Hub Placement Placing the Connection HUBConnecting the Sensor Cable to the Connection HUB MSU140 InstallationConnecting the Sensor Cable to the TABLE-TOP Sensor Removable Connector PlugConnecting the 12VDC IN-LINE Power Supply and Microflashers Installing Sensor ConnectorInstallation Mounting a Microflasher to A/V Components Mounting the Connection HUB Make sure that your system tested OK before proceedingRemoving Sensor Connector Connecting Power Supply and Flashers Running the Sensor CableReconnecting the Connection HUB Normal OperationOptional Accessories Additional SensorsAdditional Microflashers Status Feedback Wall AdapterRunning Sensor Cable in NEW Construction Scheduling and PreparationSafety First DrillingConcealing Sensor Cable in Existing Walls Pulling the CableUnobstructed space for sensor cable Routing Wire Around a Door Specifications MF1Limited Warranty Warranty Registration Card Dr. Miss Mr. Mrs. MsL e s a u d i o C o r p o r a t i o n