INSTALLATION
1.Check the specification data plate located on the bottom or right hand corner for the model number, voltage, and wattage.
2.Insure the electrical circuit used to supply electricity to the unit has the same voltage rating as indicated on the data plate and sufficient amperage rating.
3.Be sure to match the receptacle to the plug on the unit.
4.Plug cordset into outlet.
OPERATION
1.Make sure the unit is plugged into appropriate outlet.
2.Flip the On/Off Toggle Switch to the “ON” position. The terminal cables will be activated and the lights will illuminate indicating the heat is on.
CLEANING
1.Aluminum and Stainless Steel – Perform daily cleaning using only a mild
! CAUTION !
DISCONNECT POWER WHEN REPLACING OR SERVICING THERMAL CABLES AND LAMPS!
PDC Operations Manual | 3 |