Xantech RS41AV instruction

INSTALLATION INSTRUCTIONS

RS41AV

FOUR INPUT AUDIO/VIDEO REMOTE SWITCHER

GENERAL INFORMATION

•The RS41AV is a low noise, wide bandwidth, unity gain, infrared remote controlled switcher for line level stereo audio and video baseband signals.

•It selects audio and video signals from any one of four sources and sends them to one output with no signal loss.

•It allows additional source selections for the inputs of A/V receivers, VCR's, TV monitors, etc.

•A hand-held programmer, model RC68+ (available separately), is the source of the four IR input switching commands for the RS41AV (see Fig.4). Normally the installer would "teach" these commands into a Xantech Learning Remote, Key Pad or other learning device for eventual use by the customer.

•The space saving "flat pack" design allows great flexibility in mounting and positioning.

1	2	3	4	RS41AV
			VIDEO	RS41AV
			VIDEO	REMOTE SWITCHER	IR
				®	CONFIRM
				®
			AUDIO
			LEFT
			AUDIO	POWER 15VAC V	V G IR IN
			RIGHT
		INPUT		OUTPUT

Fig. 1	1	2	3	4	5	6
Fig. 1

RS41AV PANEL DESCRIPTIONS

1.INPUT jacks. Connect to the corresponding output jacks of the source components (satellite receiver, VCR, camcorder, laser disc player, TV surveillance camera, CD player, AM/FM tuner, cassette tape deck, etc.).

2.OUTPUT jacks. Connect to the corresponding input jacks of AV receivers, TV monitors, VCRs, etc.

3.POWER 15VAC V V terminals. Connect the leads of the 15V AC Power Supply (included) to these terminals (lead polarity is not required).

4.G and IR IN terminals. Input terminals for the IR control signal. Connect a 2-conductor cable from the emitter or signal output port of any Xantech Connecting Block, IR receiver, Key Pad, or Controller here. The positive lead connects to "IR IN" and the negative to "G".

5.IR CONFIRM LED. Lights continuously when power is applied. Flashes when RC68+ (and RC68) IR commands are received.

6.Mounting Holes.



Remote Control Switchers