Xantech RS41AV installation instructions Installation

CD Changer Satellite Receiver DVD Player VCR

L R V L R V L R V L R

			RCA type			286M Dual Blink-IR™
						Mouse Emitters (2)
			patch cords
1	2	3	4	RS41AV
			VIDEO			RS41AV
				REMOTE SWITCHER	CONFIRM
					IR
			AUDIO	®		Audio/Video
			LEFT			Remote
			AUDIO	POWER 15VAC V	V G IR IN	Switcher
			RIGHT
		INPUT	OUTPUT
				Power		White stripped side
IR Signal				Supply
				(included)
			RCA type	To 120 V AC		6015900
			patch cords			3.5mm to-stripped-ends
AV				(switched)
						mono cable (not included)
R L V Receiver

283M Blink IR™

Mouse Emitter (1)

490-30IR Receiver

R L V

TV

MONITOR

To 120 V AC	781RG
	Power Supply
(unswitched)

3-wire cable from	12VDC	®	789-44 CONNECTINGBLOCK	EMITTERS
	IR RCVR
	+12 VDC
additional IR	GND
receivers, keypads,	STATUS
etc. in other rooms,	IR IN

if needed.

789-44

Connecting Block

Remote Control

Fig. 3 Expanding the Source Switching of an AV Receiver

INSTALLATION

1.Code Groups: If more than one RS41AV is used in a given system, or it is included in an IR controlled system with other Xantech products that respond to RC68+ commands, different code groups can be assigned to avoid mutual interaction.

NOTE: As received from the factory, the RS41AV is set to code group 20. Refer to the RC68+ instructions for code group setting procedures.

2.Typically a programmable remote controller, such as a Xantech learning remote control or keypad, is "taught" each of the RS41AV commands (from the RC68+, Fig.4) plus the specific input command for the A/V receiver or TV monitor to which the RS41AV is connected. These commands are placed in a "sequence" or "macro". A single key press will then select the desired source connected to the RS41AV.

For "sequence" or "macro" programming, follow the instructions that come with the learning device

	
		3
RS41AV

Switchers